Abstract:Suspension plasma spray is a promising technology for surface coatings. In this work, a comprehensive numerical model was developed to investigate the multiphase flow of suspension droplets and nanoparticles in direct-current (DC) plasma spraying. A three-dimensional computational model was developed to describe the plasma jet flow fields coupled with the axial injection of suspension droplets in which the zirconia micro- and nanoparticles were dispersed. The suspension droplets were tracked using Lagrangian coordinates, considering particle heating, melting, and evaporation. After evaporation of the solvent surrounding the particle, the nanoparticles were discharged into the plasma flow. In addition to the viscous force exerted by the flow on the micrometer-sized particles, the Brownian force and the Saffman lift force were taken into account. The effects of the noncontinuum on particle momentum transfer and evaporation on heat transfer were also considered. The numerical predictions of gas flow temperature were compared with experimental data and numerical data obtained with a different computational fluid dynamics code. The agreement was reasonable. The trajectories, velocity, and temperature of nanoparticles were calculated, and compared with those of microparticles. The results showed that the Brownian force plays a major role in acceleration and heating of nanoparticles. Compared with the conventional plasma spray process with micrometer-sized feedstock, the nanoparticles in suspension plasma spraying were found to have a wider spatial distribution and higher temperature. The effects of operating parameters, such as the power input to the plasma gas and plasma gas composition, on the gas velocity and temperature were investigated. The parameters that have a significant effect on the heat and momentum transfer to the particles injected in the plasma jet were identified.

Melting Behavior of In-Flight Particles and Its Effects on Splat Morphology in Plasma Spraying

Partially Melted Particle and Its Splat Morphology

Melting and oxidation behavior of in-flight particles in plasma spray process

The Analysis of Melting and Refining Process for In-Flight Particles in Supersonic Plasma Spraying

Melting/Oxidation Behavior of In-Flight Particles in Plasma Spray Processes

Study of Injection Angle and Carrier Gas Flow Rate Effects on Particles In-Flight Characteristics in Plasma Spray Process: Modeling and Experiments

Studies of splat morphology and rapid solidification during thermal spraying

Effect of Injection Angle on Particles In-Flight Characteristics

Particle characterization and splat formation of plasma sprayed zirconia

Effects of Atomization Injection on Nanoparticle Processing in Suspension Plasma Spray

Effect of Process Parameters on Yttria‐Stabilized Zirconia Particles In‐Flight Behavior and Melting State in Atmospheric Plasma Spraying

A Volatile Spray Zone Model and Experimentation in a Gas-Solid Fluidized Bed with Liquid Injection

A Critical Assessment of Particle Temperature Distributions During Plasma Spraying: Numerical Studies for YSZ

Melting, Oxidation, Evaporation of Particle In-Flight in Plasma Spray Processes

An Investigation of Particle Injection and Resulting In-Flight Particle Behavior During Air Plasma Spraying

Dynamic Modeling of Micro- and Nano-Sized Particles Impinging on the Substrate During Suspension Plasma Spraying

Modeling of Micro- and Nanoparticle Characteristics in DC Suspension Plasma Spray

Experimental and Numerical Studies of Plasma Forming Process Parameters Effect on Optimum Particle Impact Locations

Modeling of non-Newtonian suspension plasma spraying in an inductively coupled plasma torch

Generic Correlation Of Spray Distance With In-Flight Particle Behavior For Different Kinds Of Materials In Air Plasma Spraying

Flow Characteristic of In-Flight Particles in Supersonic Plasma Spraying Process