Abstract:Fracture is the main cause of degradation and capacity fading in lithiated silicon during cycling. Experiments on the fracture of lithiated silicon show conflicting results, and so mechanistic models can help interpret experiments and guide component design. Here, large-scale K-controlled atomistic simulations of crack propagation (R-curve KI vs. Δa) are performed at LixSi compositions x=0.5,1.0,1.5 for as-quenched/relaxed samples and at x=0.5,1.0 for samples created by discharging from higher Li compositions. In all cases, the fracture mechanism is void nucleation, growth, and coalescence. In as-quenched materials, with increasing Li content the plastic flow stress and elastic moduli decrease but void nucleation and growth happen at smaller stress, so that the initial fracture toughness KIc≈1.0MPam decreases slightly but the initial fracture energy JIc ≈ 10.5J/m2 is similar. After 10 nm of crack growth, the fracture toughnesses increase and become similar at KIc≈1.9MPam across all compositions. Plane-strain equi-biaxial expansion simulations of uncracked samples provide complementary information on void nucleation and growth. The simulations are interpreted within the framework of Gurson model for ductile fracture, which predicts JIc=ασyD where α ≃ 1 and D is the void spacing, and good agreement is found. In spite of flowing plastically, the fracture toughness of LixSi is low because voids nucleate within nano-sized distances ahead of the crack (D ≈ 1nm). Scaling simulation results to experimental conditions, reasonable agreement with experimentally-estimated fracture toughnesses is obtained. The discharging process facilitates void nucleation but decreases the flow stress (as shown previously), leading to enhanced fracture toughness at all levels of crack growth. Therefore, the fracture behavior of lithiated silicon at a given composition is not a material property but instead depends on the history of charging/discharging. These findings indicate that the mechanical behavior (flow and fracture) of lithiated Si must be interpreted within a fully rate- and history-dependent framework.

Brittle Versus Ductile Fracture Mechanism Transition in Amorphous Lithiated Silicon: from Intrinsic Nanoscale Cavitation to Shear Banding

Sandwich-Lithiation and Longitudinal Crack in Amorphous Silicon Coated on Carbon Nanofibers

Size-dependent fracture of silicon nanoparticles during lithiation

In Situ Atomic-Scale Imaging of Electrochemical Lithiation in Silicon.

Two-phase electrochemical lithiation in amorphous silicon

Lithiation-induced fracture of silicon nanowires observed by in-situ scanning electron microscopy

Crack growth and fracture toughness of amorphous Li-Si anodes: Mechanisms and role of charging/discharging studied by atomistic simulations

Numerical investigation of microstructure and failure of lithiated silicon under biaxial tension

Anisotropic Swelling and Fracture of Silicon Nanowires During Lithiation.

A Chemo-Mechanical Model of Lithiation in Silicon

Microscopic Model for Fracture of Crystalline Si Nanopillars During Lithiation

Kinetics and Fracture Resistance of Lithiated Silicon Nanostructure Pairs Controlled by Their Mechanical Interaction

High damage tolerance of electrochemically lithiated silicon

Fracture Characteristic Analysis of Cellular Lattice Structures under Tensile Load

Lithium Concentration and Atomic Chain Bridging Induced Strength–Ductility Synergy in Amorphous Lithiated Sulfur Cathodes

Molecular dynamic investigation of the structure and stress in crystalline and amorphous silicon during lithiation

Atomistic Mechanisms of Phase Boundary Evolution during Initial Lithiation of Crystalline Silicon

Fracture Dynamics in Silicon Anode Solid-State Batteries

Vulnerable Window of Yield Strength for Swelling-Driven Fracture of Phase-Transforming Battery Materials

Anisotropic Fracture Dynamics Due to Local Lattice Distortions

Orientation-dependent interfacial mobility governs the anisotropic swelling in lithiated silicon nanowires.