Abstract:With the development of large span and heavy load modern engineering, concrete-filled steel tubular truss and laced column structures appear constantly. The joints of these structures are mostly circular Concrete-Filled Steel Tubular (CFST) joints. In order to solve the problem of lacking of the research on the mechanical properties of CFST joints, three CFST T-joints and one Circular Hollow Section (CHS) T-joint which was used for comparing were tested under reversed cyclic axial loading, and three CFST T-joints and one CHS T-joint were tested under reversed cyclic in-plane bending loading. The failure modes and the ultimate load carrying capacities of CFST T-joints were concluded and the load-displacement hysteretic curves were also studied. The test results showed that the failure modes of CFST joints and CHS joints with the same geometry were completely different, the ultimate load carrying capacities of CFST joints were much higher than that of CHS joints, which shows that adopting a concrete-filled chord member is the most effective way to improve the strength of the unstiffened tubular joints when subjected to axial loading and in-plane bending, the energy dissipation mechanisms of CFST joints and CHS joints were completely different, but both CFST joints and CHS joints had excellent seismic performances. The energy analysis of CFST joints under differing loading conditions indicated that there was a significant distinction in terms of the energy dissipation mechanism. The axially loaded specimens dissipated energy mainly by plastic deformation of the brace, while the in-plane bending loaded specimens dissipated energy mainly by punching shear of the chord wall at the intersection area. This research can not only provide scientific basis for the design of CFST joints, but also effectively promote the application of CFST truss and laced column, and can promote the improvement and development of the design theory of concrete-filled steel structures.

Experimental analysis of ridge joint of steel C back-to-back with plate

Experimental study of the static behavior of tubular N-joints

Experimental Investigation into Flexural Buckling of Double-Limb Built-Up Plate Members under Compression

Experimental Study on Edge Cell Partially-Replaced Joint for I-beam to Multi-Celled CFST Walls under Cyclic Loading

STIFFENER STIFFNESS AND ELASTIC BUCKLING STRESS OF STEEL PLATE SHEAR WALL

Experimental Study on Reduced I-beam to CFRST Column Joints under Cyclic Loading

Rotational performance of semi-rigid plate-type joints for reticulated shell structures composed of plate members

Experimental Investigation of Concrete-Filled Steel Tubular Longitudinal Gusset Plate Connections

Study on In-Plane Behavior of Thin-walled Concrete-filled Steel Tubular Gusset Plate T-joints

Experimental Study of Steel Plate Composite Shear Wall Units under Cyclic Load

Study Of Mechanical Performance Of Concrete-Filled Steel Tubular Joints

02.05: Design of concrete-filled steel tubular longitudinal gusset plate connections

Experimental Research on Mechanical Properties of Connection Joint Between Inclined Strut and Column in Steel Storage Rack

Compression Tests Of Cold-Formed Steel C- And Z-Sections With Different Stiffeners

Experimental study and FEM analysis on mechanical behavior of a steel tubular joint with bolted connection subject to biaxial compression

Patch-loading Resistance of QN1803 and S32001 High-Strength Stainless Steel Plate Girders: Experimental Study and Numerical Simulation

Experimental Analysis of Bolted End-Plate Connections in Steel Gable Frames

Experimental and numerical studies of a new prefabricated steel frame joint without field-welding: Design and static performance

Buckling analysis and experimental study of simply-supported single-corrugation steel plates subjected to compression

Experimental and numerical investigation on patch loading capacity of longitudinally stiffened hybrid titanium-clad bimetallic steel plate girder

Experimental study on simply supported steel plate-concrete composite beams