Abstract:One of the significant factors contributing to high energy consumption is the unutilized waste heat from flue gas in industrial boilers. Thermoelectric generator (TEG) technology can directly convert thermal energy into electrical energy, and has been gradually applied in the field of waste heat recovery due to its simple and reliable structure, environmental protection, and other advantages. In this paper, a thermoelectric generator simulation system of boiler flue gas waste heat is proposed. The experimental platform is designed by simulating the flue gas waste heat temperature condition of boiler, and the structure of cold end module and hot end module is optimized. During the experiment, the fixed temperature difference was set at 120 °C (hot end:150 °C~cold end: 30 °C). An analysis is conducted on the volt-ampere characteristics and output power of the TEG module. The output characteristics of the TEG system are analyzed under the conditions of variable load, constant load, different pump speed, different heat dissipation modes, and series and parallel connection method. The results show that the experimental platform can instantaneously and accurately test the output parameters of the TEG system, and ensure the intended design requirements. When the ratio of the load resistance to the internal resistance of the TEG module is approximately 1–1.15, the output power of the system reaches its maximum. In order to optimize the output power of the TEG system, a power prediction-based adaptive variable step size maximum power point tracking (MPPT) algorithm is introduced. Additionally, a corresponding mathematical model is formulated. Simulations demonstrate that the time of the improved algorithm to reach the stable maximum power point is 1.54 s faster than that of the traditional algorithm. The improved MPPT algorithm satisfies the criteria for speed and accuracy, diminishes superfluous energy waste, and enhances the overall system efficiency. The research results have certain guiding significance for the design and application of subsequent TEG system.

Modeling and performance analysis of a two-stage thermoelectric energy harvesting system from blast furnace slag water waste heat

Theoretical study on an integrated two-stage cascaded thermoelectric module operating with dual power sources

Exploration and optimization on thermoelectric conversion of waste heat of blast furnace slag

Modeling and verification of a thermoelectric energy scavenger

Performance Analysis on Thermal Energy Storage Unit for an Atmospheric Water Harvester in Museum Display Case

Comprehensive Performance Prediction and Power Promotion for Wearable Thermoelectric Generator with Flexible Encapsulation in Practical Application

Heat Transfer Characteristics of Thermoelectric Generator System for Waste Heat Recovery from a Billet Casting Process: Experimental and Numerical Analysis

Numerical analysis for the heat transfer behavior of steel ladle as the thermoelectric waste-heat source

Design and Research of Thermoelectric Generator Simulation System for Boiler Flue Gas Waste Heat

Performance analysis of a novel Two-stage automobile thermoelectric generator with the Temperature-dependent materials

Exergy transfer characteristics and structural parameters optimization in blast furnace slag heat recovery device

An Efficient Electrothermal Model of a Thermoelectric Converter for a Thermal Energy Harvesting Process Simulation and Electronic Circuits Powering

Modelling and Simulation Study of a Converging Thermoelectric Generator for Engine Waste Heat Recovery

Design of Bi2Te3-based thermoelectric generator in a widely applicable system

Numerical and Experimental Study on Performance of a Low-Backpressure Polyhedral Thermoelectric Generator for Waste Heat Recovery

Dynamic study for performance improvements of a thermo-mechanically bistable heat engine

Performance of a thermoelectric generator system for waste heat recovery utilizing plate fin heat sink in bronze ingot casting industry

Performance prediction and manipulation strategy of a hybrid system based on tubular solid oxide fuel cell and annular thermoelectric generator

Experimental Investigation and Modeling of Cooling Processes of High Temperature Slags

Performance analysis of alkali metal thermoelectric converter and segmented thermoelectric generator hybrid system based on a comprehensive model

Study of Different Heat Exchange Technologies Influence on the Performance of Thermoelectric Generators