Abstract:In this paper, a series of experiments including room-temperature low-cycle fatigue tests, instrumented indentation measurements, optical microscopy examinations, etc. were carried out to study the local mechanical properties and microstructures in particular zones of 304L SS welded joints in both the as-welded and cyclic straining conditions. An analytical algorithm proposed by Dao et al. [12] was utilized to estimate the basic mechanical properties (E, σy and n) from the indentation load-depth data. It is shown that in the as-welded condition, the weld metal has a higher strength and strain hardening capacity but a lower stiffness than does the base metal, while the material within HAZ exhibits a significant gradient of the mechanical properties. A strain amplitude-dependent variation in the local mechanical properties in particular joint regions was also obtained. Optical microscopy examinations showed that the microstructure in particular zones of 304L SS welded joints was not only decided by the metallurgical condition resulting from the welding process, but also determined by the strain amplitude applied during cyclic straining. In this study, an empirical criterion for judging the fracture locations of a weldment based on the yield stress mismatch ratio was also introduced to assess the integrity of the present 304L SS welded joints subjected to low-cycle fatigue loadings. The research work performed in this paper would further expand the applications of instrumented indentation technique in fatigue strength analysis of welded components.

Test and Analysis of the Mechanical Properties for Laser-Welding Seams and Spot-Welding Joints

Use of instrumented indentation testing to study local mechanical properties of 304L SS welded joints subjected to low-cycle fatigue loadings

A study of local mechanical properties of 304L SS welded joints subjected to cyclic straining using depth-sensing instrumented indentation

Microstructures and Mechanical Properties on Laser Welded Joints of Automotive High Strength Complex Phase Steel

Finite Element Modeling of Laser Spot Welded Lap Joint

Study on Joint Residual Stress Induced by Laser Beam Welding of High Strength Automobile Thin Sheet

Microstructures and properties of sandwich plane laser-welded joint of hull steel

Investigation of Mechanical Behavior of Weld Seams of Composite Envelopes in Airship Structures

Mechanical Characterization and Prediction of Aluminum Alloy Laser Welding Joints Including Roles of Geometries and Porosity

FEM analysis of spot welding process in autobody manufacturing

Numerical Modelling and Experimental Verification of Thermal Characteristics and Their Correlations with Mechanical Properties of Double-Sided Laser Welded T-joint

Joint Strength and Failure Mechanism of Laser Spot Weld of Mild Steel Sheets under Lap Shear Loading

The influence of adhesive viscosity and elastic modulus on laser spot weld bonding process

Research on laser welding of vehicle body

Studies on a computational model and the stress field characteristics of weld-bonded joints for a car body steel sheet

Measurement and Simulation of Residual Stresses in Laser Welded CFRP/steel Lap Joints

Weld morphology and mechanical properties in laser spot welding of quenching and partitioning 980 steel

Study of Microstructural Inhomogeneity and Its Effects on Mechanical Properties of Multi-Layer Laser Welded Joint

Finite element simulation of laser-generated ultrasonic waves for quantitative detection of internal defects in welds

Research on Mechanical Properties of Locking Cap Lap Welds and Partitioned Seam Weld Model

A Study of the Performance of Dissimilar Pulsed-Laser-Welded JSC590R/JAC980YL Steel Joints of Differential Thickness