Abstract:New time-based readout (TBR) electronics has been developed and evaluated for its performance and application for PET detectors. It consists of a leading edge (LE) timing threshold for timing pickoff that provides a signal timing t1; a charge integration followed by a constant discharge between two specific timings t2 and t3 that are used to directly measure the signal energy. The timing-walk error caused by LE from signals of different amplitudes can be measured with t1 as a function of different signal amplitudes that is proportional to the time difference between t2 and t3. With this pre-calibration, timing-walk error can be accurately corrected. Therefore, both signal timing and energy can be accurately measured with digital timing signals without using CFD and ADC. These timing signals were controlled and in principle can be measured by an FPGA that can apply many signal logic and data correction algorithms. A single channel discrete component TBR circuit has been implemented in PC board, and 8-channel ASIC chips have been developed for feasibility evaluations and PET detector applications. Initial functionality and performance evaluations have been conducted. Signal amplitude measurement accuracy and linearity are very good; the measured timing accuracy from a pulse is the same as a standard CFD and reaches to similar to 100 ps resolution with the test setup. Both suitable energy and coincidence timing resolutions (similar to 17% and similar to 1.0-2.0 ns) were achieved with PMT or Solid-State PM (SSPM) array based PET detectors. Initial studies to acquire flood source crystal identification map has demonstrated the advantages of applying parallel readout with TBR electronics that read out and process signals from each pixel of SSPM array independently. With its relatively simple circuit and low cost, TBR electronics is expected to provide suitable front-end signal readout electronics for compact photon detectors such as SSPM array that require large number of output channels and demand high performance in energy and timing.

The Design Of A Subnanosecond Time Resolution Readout System For Pulsar-Based Navigation

Prototype Design of Readout Electronics for In-Beam TOF-PET of Heavy-Ion Cancer Therapy Device

Time and Energy Measurement Electronics for Silicon Drift Detector Aimed for X-ray Pulsar Navigation

A Two-Step Time-to-Digital Converter with 5.6ps Resolution and 1 - 4255μs Measurement Range

Design of 32-channel TDC Based on Single FPGA for μSR Spectrometer at CSNS

A Novel Pulsar Analog Front-end for Grid Synchronized Measurement.

A simulation experiment system for X-ray pulsar based navigation

Ensuring Grid Synchronization with Pulsar Timing: Novel Analog Front-End Circuit and Pulse Extraction Framework

Development of Real-time High-Density Pulsar Data Transmission and Processing for Grid Synchronization

Signal Processing for Pico-second Resolution Timing Measurements

Subnanosecond Time-to-Digital Converter Implemented in a Kintex-7 FPGA

Measurement of X-ray photon energy and arrival time using a silicon drift detector

Low-cost FPGA-based multi-channel TDC with high resolution and density for time-of-flight detectors

Development of a 256-channel Time-of-flight Electronics System For Neutron Beam Profiling

Implementation of sub-nanoseconds TDC in FPGA: applications to time-of-flight analysis in muon radiography

Energy And Timing Measurement Of A Pet Detector With Time-Based Readout Electronics

Research of the navigation accuracy for the X-ray pulsar navigation system

A 3.9-ps RMS Precision Time-to-Digital Converter Using Ones-Counter Encoding Scheme in a Kintex-7 FPGA

A Highly Linear FPGA-Based TDC and a Low-Power Multichannel Readout ASIC with a Shared SAR ADC for SiPM Detectors

Readout Electronics Development Based on an ASIC for PET Detector Using PMT-quadrant-sharing

A Design of High Resolution One-Clock-Cycle TDC Based on FPGA