Abstract:One of the important failure criteria of press operations in industry for forming simulations is the Forming Limit Diagram (FLD). The complex loading effects on FLD, in particular the localized necking phenomenon under stretch-bending condition, have not been fully investigated and well understood. In practical sheet metal applications, the deformation is invariably three dimensional with a combination of stretching and bending. For most sheet materials under these complex loading processes used in industry, strong Bauschinger effect is observed, and the material hardening behavior tends to be anisotropic. This study aims to understand and evaluate such anisotropic hardening effect on the forming limit prediction under stretch-bending condition. The extended through-thickness Marciniak–Kuczynski (M–K) analysis is incorporated with Yoshida–Uemori (YU) two-surface kinematic hardening constitutive model, which has a more accurate description of the reverse loading behavior than that of the conventional isotropic hardening model. The material parameters used in this paper for YU model are calibrated with the experimental data from uniaxial large-strain tension-compression cyclic test. Both the isotropic hardening and YU kinematic hardening models with Hill'48 yield surface are employed in the analysis for the purpose of comparison. The Forming Limit Average Stress Diagram (FLASD) under stretch-bending condition is proposed to extend the understanding of Forming Limit Stress Diagram (FLSD) from in-plane to out-of-plane deformations. The “bending-ratio-dependent” phenomenon in forming limit diagram is predicted and observed in both stress/strain space with the proposed method. It suggests that the individual stress/strain state cannot represent system behavior. Forming limits under stretch-bending is suggested as an occurrence of system instability, not individual material instability. The system behavior of sheet metal deformation is reinforced as critical to the understanding of necking instability in stretch bending processes. The analysis shows that the Bauschinger effect provides positive effect in delaying the necking instability, predicting higher formability for sheet metals under stretch-bending. The insight obtained in this paper provides further understanding of the localized necking phenomenon under stretch-bending condition.

Analytical Study of the Effect of Material Properties on the Formability of Sheet Metals Based on the M-K Model

Forming Limit Calculation Based on the M-K Model with Yld96 Yield Function

An extended mesoscaled M-K model for predicting discrete ultimate strains and evaluating the effect of normal stress on forming limits

Sheet metal forming limits under stretch-bending with anisotropic hardening

Investigation on the Material Constitutive Model in Sheet Metal Forming

An improved Marciniak-Kuczynski approach for predicting sheet metal formability

Forming Limit Model Evaluation for Anisotropic Sheet Metals under Through-Thickness Normal Stress

New Robust Algorithms for Marciniak–Kuczynski Model to Calculate the Forming Limit Diagrams

Effect of nonlinear strain paths on forming limits under isotropic and anisotropic hardening

A review of research in macroscopic hardening models in numerical simulation of sheet metal forming

M–K Analysis of Forming Limit Diagram under Stretch-Bending

PREDICTION OF FORMING LIMIT DIAGRAMS OF DP590 STEEL BASED ON THE M-K MODEL WITH EXPERIMENTAL VERIFICATION

Forming Limits under Stretch-Bending Through Distortionless and Distortional Anisotropic Hardening

Influence of Material Models on the Accuracy of the Sheet Forming Simulation

Forming Limit Evaluation for AA5182 Aluminum Alloy at Warm Temperatures Based on M–K Model

Prediction of Forming Limit for Aluminum Alloy Sheet Coupling with Temperature and Strain Rate

Forming Limits of a Sheet Metal after Continuous-Bending-Under-Tension Loading

Research on material flow stress models in common use

Modelling the anisotropy evolution in sheet metals with heterogeneous properties

Forming Limit Evaluation by Considering Through-Thickness Normal Stress: Theory and Modeling

Forming Limit Analysis of BCC Sheet Metal by Using Crystalline Plasticity Model