Abstract:Calcareous sand has been used as the main filling material in numerous reef constructions. Therefore, understanding its long-term dynamic engineering geological characteristics under cyclic applications of traffic or wave loading is crucial to the design and prediction of the serviceability of reef infrastructures. Considering this, seven monotonic triaxial tests and 33 high-cycle (25,000 cycles) drained triaxial tests were conducted on calcareous sand with various mean effective stresses (p') and cyclic stress ratios (ζ). The results show that the development of the accumulated axial strain (ε1acc) has a strong correlation with the positional relationship between the cyclic stress path and critical strength line (CSL) or static strength envelope (SSE) in the p'-q plane. The critical cyclic stress ratio ζc, that represents the cyclic stress path reaching the CSL, is proposed. When ζ>ζc, the growth rate of ε1acc with ζ increases drastically. Moreover, when the cyclic stress path approaches the SSE, ε1acc enters an incremental collapse state. The increase in p' diminishes the dilatancy of the volumetric strain εv. However, this response of εv reverses from decreasing to increasing with increasing ζ. The resilient modulus (Mr) increases with the number of cycles (N) due to the initial densification. If εv dilation occurs, Mr will decrease with N as particles lose contact. A single parameter for the cyclic stress path ratio (ψ) considering the effects of p', ζ, and SSE is proposed. Additionally, empirical formulas for calculating the ultimate ε1acc and Mr are established. Furthermore, particle degradation significantly worsens ε1acc and εv, but has a more profound effect on the compressibility of εv. This degradation is also detrimental to Mr. A certain deviation trend of the predicted values from the measured values is found to correspond with the relative particle breakage.

Laboratory Test on Volumetric Characteristics of Saturated Sea Sand under Cyclic Loading

Failure Mechanisms of Sand under Asymmetrical Cyclic Loading Conditions: Experimental Observation and Constitutive Modelling

Effects of Initial Static Shear on Cyclic Resistance and Pore Pressure Generation of Saturated Sand

Undrained Behavior of Sand under Cyclic Paths That Match Storm-Wave Loading Conditions

Discrete-Element Simulation of Dense Sand under Uni- and Bidirectional Cyclic Simple Shear Considering Initial Static Shear Effect

Flow Deformation and Cyclic Resistance of Saturated Loose Sand Considering Initial Static Shear Effect

Permanent Deformation Characteristics of Saturated Sand under Cyclic Loading

Experimental Research On Behaviors Of Saturated Loose Sand Subjected To Oblique Ellipse Stress Path

Liquefaction of Sand under Monotonic and Cyclic Shear Conditions: Impact of Drained Preloading History

Stress-strain Response of Saturated Sand During Cyclic Water Absorption Shearing

Experimental study on reconsolidation on reconsolidation volumetric behavior of sand-gravel composites due to dynamic loading

A New Parameter to Evaluate Liquefaction Resistance of Saturated Sand under Complex Dynamic Stress Paths

Experimental Investigation of the Liquefaction Properties and Post-Liquefaction Volumetric Strain of Calcareous Sand in Dredger Fill Site

Laws of volumetric deformation and particle breaking of calcareous sand under cyclic loading

Laboratory study on the mechanism and behaviour of saturated sand-gravel composites

Long-term behaviour and degradation of calcareous sand under cyclic loading

Study of Dynamic Pore Water Pressure and Axial Strain in Saturated Sand-Gravel Composites

Experimental Study on Undrained Behavior of Saturated Silt Subject to Wave Loading

Experimental Investigation of Cyclic Failure Mechanism of Saturated Coral Sand under Various Consolidation Conditions

Effects Of Cyclic Loading Directions On Liquefaction Characteristics Of Saturated Coral Sand

Experimental Study on the Influence of Cyclic Loading Frequency on Liquefaction Characteristics of Saturated Sand