Abstract:In string musical instruments, the sound is radiated by the soundboard, subject to the strings excitation. This vibration of this rather complex structure is described here with models which need only a small number of parameters. Predictions of the models are compared with results of experiments that have been presented in Ege et al. [Vibroacoustics of the piano soundboard: (Non)linearity and modal properties in the low- and mid- frequency ranges, Journal of Sound and Vibration 332 (5) (2013) 1288-1305]. The apparent modal density of the soundboard of an upright piano in playing condition, as seen from various points of the structure, exhibits two well-separated regimes, below and above a frequency flim that is determined by the wood characteristics and by the distance between ribs. Above flim, most modes appear to be localised, presumably due to the irregularity of the spacing and height of the ribs. The low-frequency regime is predicted by a model which consists of coupled sub-structures: the two ribbed areas split by the main bridge and, in most cases, one or two so-called cut-off corners. In order to assess the dynamical properties of each of the subplates (considered here as homogeneous plates), we propose a derivation of the (low-frequency) modal density of an orthotropic homogeneous plate which accounts for the boundary conditions on an arbitrary geometry. Above flim, the soundboard, as seen from a given excitation point, is modelled as a set of three structural wave-guides, namely the three inter-rib spacings surrounding the excitation point. Based on these low- and high-frequency models, computations of the point-mobility and of the apparent modal densities seen at several excitation points match published measurements. The dispersion curve of the wave-guide model displays an acoustical radiation scheme which differs significantly from that of a thin homogeneous plate. It appears that piano dimensioning is such that the subsonic regime of acoustical radiation extends over a much wider frequency range than it would be for a homogeneous plate with the same low-frequency vibration. One problem in piano manufacturing is examined in relationship with the possible radiation schemes induced by the models.

Effect of Vibration Properties of a Resonance Board on Piano Timbre

Influence of the Vibrational Properties of the Resonance Board on the Acoustical Quality of A Piano

Acoustic Performance of Picea Resonance Board and Differences in Human Physiological Responses

Measurement and Analysis of the Vibration Responses of Piano Soundboards with Different Structures

Vibrational and acoustical characteristics of the piano soundboard

Modal Analysis of Upright Piano Soundboards by Combining Finite Element Analysis and Computer-Aided Design

Research on vibration property of Picea wood for piano sound quality neural network and ant colony algorithm

Vibroacoustics of the piano soundboard: (Non)linearity and modal properties in the low and mid-frequency ranges

Experimental Investigation of the Effects of Extra Mass on a Piano Soundboard’s Vibration Property

Test and Adjustment of the Vibration Mode of Piano Soundboard

Comparison of the vibroacoustical characteristics of different pianos

Experimental Research on Measuring Coupling Oscillations of Piano String Board

Vibroacoustics of the piano soundboard: Reduced models, mobility synthesis, and acoustical radiation regime

Acoustic Vibration Property of Full-Size Spruce Wood Soundboard of Musical Instruments

Tonal Characterisation of a Wooden Resonance Box

Vibration Testing for the Evaluation of the Effects of Moisture Content on the In-Plane Elastic Constants of Wood Used in Musical Instruments

Vibration Modal Analysis of Resonance Board of Ruan and Yukin

Modulating the Acoustic Vibration Performance of Wood by Introducing a Periodic Annular Groove Structure

Effects of Variance Coefficient of Growth Ring Width on Sound Vibration Parameters of Picea Wood

Acoustic vibration properties of wood for musical instrument based on FFT of adding windows

Study on Acoustic Vibration Performance of Wood-Carbon Fiber Composite Materials with Different Laying Patterns