Abstract:Although spinel Li4Ti5O12 is an attractive anode material for lithium-ion batteries (LIBs), it suffers from its poor rate performance. To improve the rate performance, a Li3.9Cu0.1Ti5O12 and carbon nanotubes (CNTs) composite was fabricated through mixing CNTs with Li3.9Cu0.1Ti5O12 particles. X-ray diffraction combined with Rietveld refinement, X-ray photoelectron spectroscopy, field emission scanning electron microscope, transmission electron microscope, nitrogen adsorption–desorption measurement, electrochemical impedance spectroscopy, two-terminal electronic conductivity test and galvanostatic discharge–charge test were employed for the characterizations. The Cu+ substituting negligibly changed the particle size but modified the crystal structure. Consequently, the electronic and Li+ ion conductivities of Li3.9Cu0.1Ti5O12 were respectively increased to 4.0×10−8 S cm−1 and 5.6×10−7 S cm−1, which are at least forty and four times larger than those of the pristine Li4Ti5O12. Through incorporating CNTs, the electrical conduction between the Li3.9Cu0.1Ti5O12 particles was enhanced. As a result of these simultaneous improvements arising from the synergistic effect combining intrinsic improvement by Cu+ substituting and extrinsic enhancement by CNTs compositing, Li3.9Cu0.1Ti5O12/CNTs shows a significantly improved rate performance, which is better than those of Li3.9Cu0.1Ti5O12, Li4Ti5O12/CNTs and Li4Ti5O12. The specific capacity of Li3.9Cu0.1Ti5O12/CNTs at 10C is up to 103 mAh g−1 between 1.0 and 2.5V (vs. Li/Li+), in contrast to those of Li3.9Cu0.1Ti5O12, Li4Ti5O12/CNTs and Li4Ti5O12 to be only 29, 68, 12 mAh g−1 at the same rate. In addition, Li3.9Cu0.1Ti5O12/CNTs exhibits high cyclic stability with capacity retention of 96.3% over 100 cycles. These advanced electrochemical performances may render Li3.9Cu0.1Ti5O12/CNTs a promising candidate for the anodes of high-power LIBs.

In situ fabrication of Li4Ti5O12@CNT composites and their superior lithium storage properties

Nanocomposites As Anode for Lithium-Ion Battery

Structure and Electrochemical Properties of Spinel Li4ti5o12 Nanocomposites As Anode for Lithium-Ion Battery

Electrochemical performance of TiO 2 /carbon nanotubes nanocomposite prepared by an in situ route for Li-ion batteries

Electrochemical performance of Li 4 Ti 5 O 12 /carbon nanofibers composite prepared by an in situ route for Li-ion batteries

In situ growth of coiled carbon nanotubes on LiFePO 4 as high performance lithium storage material

Improved Lithium Storage Performance of NaTi2(PO4)(3)/C Composite Connected by Carbon Nanotubes

Enhanced Electrochemical Performance of Li4Ti5O12 As Anode Material for Lithium-Ion Batteries with Different Carbons As Support

Facile Preparation of Li4Ti5O12/AB/MWCNTs Composite with High-Rate Performance for Lithium Ion Battery

Nitrogen-Doped Carbon Coated Li4ti5o12-Tio2/Sn Nanowires And Their Enhanced Electrochemical Properties For Lithium Ion Batteries

Synthesis and electrochemical performance of Li4Ti5O12/TiO2/C nanocrystallines for high-rate lithium ion batteries

Synthesis and Performance of Carbon Nano-Tube Modified Lithium Titanium Oxide

Preparation of Carbon Nanotube Coated Li4Ti5O12 Nanosheets Heterostructure As Ultrastable Anodes for Lithium-Ion Batteries

Advanced electrochemical performance of Li4Ti5O12-based materials for lithium-ion battery: Synergistic effect of doping and compositing

Preparation and electrochemical performance of Li2MnSiO4/CNTs composite cathode material for lithium ion batteries

Superior Rate Performance of Li 4 Ti 5 O 12 /tio 2 /c/cnts Composites Via Microemulsion-Assisted Method As Anodes for Lithium Ion Battery

Li3.9Cu0.1Ti5O12/CNTs Composite for the Anode of High-Power Lithium-Ion Batteries: Intrinsic and Extrinsic Effects

In Situ Growth of Carbon Nanotube Wrapped Si Composites As Anodes for High Performance Lithium Ion Batteries.

Nano/micrometer porous conductive network structure Li 4 Ti 5 O 12 @C/CNT microspheres with enhanced sodium-storage capability as an anode material.

Li4Ti5O12 Nanowires Intertwined with Carbon Nanotubes for Ultra-Long Life and Conductive Additive-Free Anodes of Lithium-Ion Batteries

Li4ti5o12 Co-Modified with Carbon Nanotubes and Pyrolytic Carbon As an Advanced Anode Material for Lithium-Ion Batteries