Modeling of Tensile Residual Stresses Extending More Than 5 Weld Widths From Weld Joint

william mohr,yuping yang

DOI: https://doi.org/10.1115/PVP2014-28042

2014-01-01

Abstract:Welding residual stresses around a cylindrically symmetric weld between two steel components, a necked steel forging and a uniform thickness plate, were modeled using a finite-element modeling approach. The modeling included a preheat period, a 22-pass weld and a limited cooling rate after welding, all with a sequential thermal and mechanical analysis approach. The configuration, with a J-groove bevel at the outside of the forging flange, allowed the flange to be joined to a thick steel plate. Welding residual stresses were large and tensile in the weld area. A region of surface residual tensile stress on the flange extended to the neck at more than 5 weld widths from the weld joint in a region that was not heated more than 100 C. Modifications of the welding to reduce the driving forces for residual stress changed the distribution near the weld, but did not greatly affect the remote stresses. A change of fixturing on the faying surface did significantly reduce the remote tensile stresses by more than 30%.