Abstract:The ability to reliably determine the structural integrity of timber bridges is currently a challenge facing structural engineers. In Australia, Local Government is responsible for the operational management and maintenance of over 20,000 bridges. More than 70% of these bridges comprise aging timber bridges, the load capacity and structural adequacy of many of which have been impaired over time. A major challenge facing Local Government nationally is to develop effective strategies for the maintenance and rehabilitation of the extensive timber bridge stocks which form a key component of the road network under its control. Raising the efficiency and reliability of bridge maintenance practices of local government has the potential not only to minimise costly unscheduled emergency repairs, but also to reduce the overall maintenance costs, whilst improving the operational effectiveness of its road network. Responding to the needs, through a series of research and development projects, a simple dynamic testing method, based on the Structural Frequency Shift (SFS), was developed by authors (Benitez and Li (2002), Samali et al (2003a), Samali et al (2003b)) to lower the cost and shorten the testing time. The method has recently been successfully used to undertake field-testing of more than 60 timber bridges across NSW. The testing procedure involves the attachment of accelerometers underneath the bridge girders and exciting the bridge with a modal hammer with and without extra mass blocks at mid-span of the bridge. In order to refine the method and to further reduce cost and testing time as well as evaluate some of the practical issues during the field testing, a project has been initiated to investigate the effects of using alternative mass forms, such as use of a trailer to replace currently used mass blocks, and adding mass at locations other than mid-span, on the bridge vibrations and subsequent integrity assessment. In this paper, and after reviewing the SFS method, analytical and experimental investigations have been carried out to address the above-mentioned issues. The equivalent modal masses have been derived and used to normalise the analytically derived formula for other than mid-span mass locations. A beam with attached spring and masses was used to model the alternative mass, such as a trailer, for bridge testing. Experimental verifications have confirmed a good agreement with the analytical/numerical results.

Rapid Impact Testing For Quantitative Assessment Of Large Populations Of Bridges

Remotely Collaborative Pseudo-Dynamic Testing Of A Multi-Span Bridge

Rapid Impact Testing and System Identification of Footbridges Using Particle Image Velocimetry

A new impact testing method for efficient structural flexibility identification

Rapid Estimation of Bridge Key Deflection Through Optimized Substructural Impact Testing

Mobile Impact Testing of a Simply-Supported Steel Stringer Bridge with Reference-Free Measurement

Structural Flexibility Identification by Integrating Substructures' Measurements

Structural Identification Study of a Steel Multi-Girder Bridge Based on Multiple Reference Impact Test

Structural Identification of Short/middle Span Bridges by Rapid Impact Testing: Theory and Verification

Mobile Impact Testing for Structural Flexibility Identification with only a Single Reference.

Continuous Force Excited Bridge Dynamic Test and Structural Flexibility Identification Theory

Vision-based Structural Scaling Factor and Flexibility Identification Through Mobile Impact Testing

Flexibility Identification and Deflection Prediction of a Three-Span Concrete Box Girder Bridge Using Impacting Test Data

Theoretical and Experimental Studies on Assessment of Bridges Using Simple Dynamic Procedures

Bridge Flexibility Identification Through a Reference-Free Substructuring Integration Method Driven by Mode Fitting

Completely Non-Contact Modal Testing of Full-Scale Bridge in Challenging Conditions Using Vision Sensing Systems

Innovative Bridge Condition Assessment from Dynamic Response of A Passing Vehicle

A Computer Vision–aided Methodology for Bridge Flexibility Identification from Ambient Vibrations

ASSESSING THE STRUCTURAL ADEQUACY OF TIMBER BRIDGES USING DYNAMIC METHODS

xImpact: Intelligent Wireless System for Cost-Effective Rapid Condition Assessment of Bridges under Impacts

Theoretical and Experimental Investigations of Identifying Bridge Damage Using Instantaneous Amplitude Squared Extracted from Vibration Responses of a Two-Axle Passing Vehicle