Abstract:Coupling effects of various loading conditions can cause deflections, settlements and even failure of in-service bridges. Although it is one of the most critical loads, unfortunately, loading conditions of moving vehicles are difficult to capture in real time by bridge monitoring systems currently in place for sustainable operation. To fully understand the status of a bridge, it is essential to obtain instantaneous vehicle load distributions in a dynamic traffic environment. Although there are some methods that can identify overweight vehicles, the captured vehicle-related information is scattered and incomplete and thus cannot support effective bridge structural health monitoring (BSHM). This study proposes a noncontact, vision-based approach to identification of vehicle loads for real-time monitoring of bridge structural health. The proposed method consists of four major steps: (1) establish a dual-object detection model for vehicles using YOLOv7, (2) develop a hybrid coordinate transformation model on a bridge desk, (3) develop a multiobject tracking model for real-time trajectory monitoring of moving vehicles, and (4) establish a decision-level fusion model for fusing data on vehicle loads and positions. The proposed method effectively visualizes the 3D spatiotemporal vehicular-load distribution with low delay at a speed of over 30FPS. The results show that the hybrid coordinate transformation ensures that the vehicle position error is within 1 m, a 5-fold reduction compared with the traditional method. Wheelbase is calculated through dual-object detection and transformation and is as the primary reference for vehicle position correction. The trajectory and real-time speed of vehicles are preserved, and the smoothed speed error is under 5.7%, compared with the speed measured by sensors. The authors envision that the proposed method could constitute a new approach for conducting real-time SHM of in-service bridges.

Flexibility matrix identification using the moving vehicle induced responses for beam type bridge

Identification of a Moving Mass on a Beam Bridge Using Piezoelectric Sensor Arrays

Time‐varying frequency‐based scaled flexibility identification of a posttensioned concrete bridge through vehicle–bridge interaction analysis

Mode Shape Identification and Damage Detection of Bridge by Movable Sensory System

Kalman Filter Based Estimation of Neutral Axis Position of Bridge Deck under Traffic Loading

Structural damage identification based on dynamic deflection sensitivity of bridge under vehicle loading

Static and dynamic vehicle load identification with lane detection from measured bridge acceleration and inclination responses

Bridge Modal Identification using Acceleration Measurements within Moving Vehicles

Dynamic displacement estimation and modal analysis of long-span bridges integrating multi-GNSS and acceleration measurements

A bridge dynamic response analysis and load recognition method using traffic imaging

Identification of Ship Collision Damage to Non-Navigable Span Bridge of Sea-Crossing Bridge Based on Flexibility Matrix

Bridge Damage Identification Using Vehicle Bump Based on Additional Virtual Masses

Bridge damage identification based on synchronous statistical moment theory of vehicle–bridge interaction

Quasi-Static Influence Line Identification and Damage Identification of Equal-Span Bridges Based on Measured Vehicle-Induced Deflection

Computer Vision-Based Real-Time Identification of Vehicle Loads for Structural Health Monitoring of Bridges

Numerical Investigation of the Vibration Performance of Elastically Supported Bridges Under a Moving Vehicle Load Based on Impact Factor

Intelligent identification of moving forces based on visual perception

Bridge modal identification based on successive variational mode decomposition using a moving test vehicle

Vibration Analysis of Bridge Subjected to a Moving Elastic Vehicle Ith Flexible Connections

Research on damage identification of simply supported bridge based on effect size method for vehicle-bridge coupled vibration