Abstract:This study aimed to address the issue of rapid electron–hole recombination in photocatalysis by exploiting multi-phase TiO 2 decorated on multiwalled carbon nanotubes (MWCNTs) to improve the photocatalytic degradation of dyes. A simple and eco-friendly one-pot method was utilized to create the TiO 2 /MWCNT nanostructure using glucose as both a structure-directing agent and a carbon source without requiring any prior covalent or non-covalent functionalization of the MWCNTs at 160 °C. Furthermore, it was found that the average width of the nanocomposites changed from 20 ± 1 and 42 ± 2 nm to 56 ± 3 nm, corresponding to MWCNT contents of 1.0, 2.0, and 3.0 (wt%), respectively. Specifically, TiO 2 /MWCNTs with a low content of MWCNTs demonstrated enhanced performance for the photocatalytic degradation of dyes, with the bandgap of the nanocomposites decreasing to 2.5 eV with 1.0% MWCNTs and 2.4 eV with 2.0% MWCNTs. The TiO 2 /MWCNT-1.0 catalyst demonstrated high photocatalytic efficiency for methylene blue (MB) degradation with a rate constant of 0.0051 min −1 . TiO 2 /MWCNT-2.0 was more effective for rhodamine (RhB) degradation than pristine TiO 2 , with a rate constant of 0.0065 min −1 within 120 min of solar-light exposure. This novel modified approach can be used to synthesize nanocomposites simply and is potentially feasible for efficient dye degradation and beyond, offering a promising solution for water-pollution treatment.

A green method to prepare TiO2/MWCNT nanocomposites with high photocatalytic activity and insights into the effect of heat treatment on photocatalytic activity

Temperature-dependent differences in wettability and photocatalysis of TiO 2 nanotube arrays thin films

Hydrothermal synthesis and photocatalytic activity of combination of flowerlike TiO2 and activated carbon fibers

Preparation and Photocatalytic Activities of TiO2 Nanotubes with Mixed Crystal Structure

Preparation and Properties of TiO2/Bentonite Composite Photocatalytic Materials at Room Temperature

Hydrothermal synthesis of TiO2/Ti3C2 nanocomposites with enhanced photocatalytic activity

Composite of TiO2 Nanoparticles and Carbon Nanotubes Loaded on Poly(methyl Methacrylate) Nanofibers: Preparation and Photocatalytic Performance

Modified hydrothermal method for synthesizing titanium dioxide-decorated multiwalled carbon nanotube nanocomposites for the solar-driven photocatalytic degradation of dyes

One-pot Hydrothermal Synthesis of the Dual-Phase Anatase/tio2-B Nanoparticles with K2Ti6O13 Nanofibers for Enhanced Photocatalysis

Photocatalytic Performance of MWCNTs/TiO2 Nanocomposites: Conventional Vs. Microwave-Assisted Synthesis

Low Temperature Synthesis of Few-Layer Titanate Nanobelts on Ti Mesh and the Hot-Water Induced Transformations to Highly Photocatalytic Active Titania Nanorods

Preparation of TiO2 Nanofibres and Influence of Calcination Temperature on Photocatalytic Activity

Photocatalytic Properties and the Role of Carbon Nanotubes in Tio2/Carbon Nanotube Composites

Enhancement of the visible light photocatalytic activity of C-doped Tio2 nanomaterials prepared by a green synthetic approach

Fabrication and Performances of MWCNT/TiO 2 Composites Derived from MWCNTs and Titanium (IV) Alkoxide Precursors

TiO2 Nanotubes/MWCNTs Nanocomposite Photocatalysts: Synthesis, Characterization and Photocatalytic Hydrogen Evolution under UV-Vis Light Illumination

Hydrothermal Preparation of TiO2 Nanotubes and Its Photocatalytic Performance

Effect of Hydrothermal Temperature on the Materials Properties and Its Visible Light Photocatalytic Efficiency of Nanozised TiO_2 Powder

Heterostructure composites of TiO2 and CdZnS nanoparticles decorated on Ti3C2Tx nanosheets and their enhanced photocatalytic performance by microwave hydrothermal method

Preparation and Photocatalytic Degradation of CNT/TiO₂ Composites Using MWCNT and Various Titanium Alkoxide Precursors

In-situ fabrication of TiO 2 -MWCNT composite for an efficient electron transfer photocatalytic rhodamine B dye degradation under UV–visible light