Abstract:The search continues for alternative nontoxic n-type electron transport layers in optoelectronic thin-film devices. Indium oxysulfide, In 2 (O,S) 3 , represents one promising material for this application, especially when paired with chalcogenide absorber layers. The ternary nature of the composition allows for electrical conductivity and optical bandgap tuning by tailoring the sulfur to oxygen ratio in the oxysulfide alloy. However, thin films of In 2 (O,S) 3 are typically deposited only by chemical bath deposition or plasma-enhanced atomic layer deposition. We report deposition of thin films of In 2 (O,S) 3 in a custom-built thermal reactor using only water vapor and hydrogen sulfide as the coreactants. This advance is enabled by the use of a recently reported, highly reactive indium formamidinate precursor. As shown by x-ray photoelectron spectroscopy, the composition can be tuned from pure In 2 O 3 to pure In 2 S 3 by varying the ratio of cycles employing water or hydrogen sulfide. The oxygen to the sulfur ratio in the film can be controlled by altering the dose sequence, although films typically contain more sulfur than would be expected naively from the percentage of hydrogen sulfide doses in the deposition recipe. Rutherford backscattering spectrometry confirms the composition is sulfur-rich relative to the dosing ratio. Structural characterization indicates films are relatively amorphous in nature. Electrically, these films offer reasonably constant electron mobility at different O:S ratios, with an electron concentration tunable over 4 orders of magnitude. These oxysulfide films possess a higher indirect bandgap than their oxygen-free indium sulfide counterparts, indicating higher transmittance to blue light. These indium oxysulfide films may be suitable candidates for electron transport layers in thin-film solar cells where their wider bandgap might result in higher optical transparency and thus short circuit current density, while the tunability of their conduction band offset with an absorber layer may result in higher open circuit voltage.

Growth of Polycrystalline In2S3 Thin Films by Chemical Bath Deposition Using Acetic Acid As a Complexing Agent for Solar Cell Application

Characterization of Thermally Evaporated In2S3 Films for Solar Cell Application

Fabrication and characterization of CuInS 2 films by chemical bath deposition in acid conditions

Effect of Substrate Temperature on Structural and Optical Properties of In2S3 Thin Films Grown by Thermal Evaporation

Preparation and Characterization of Cuins2 Thin Films for Solar Cells by Chemical Bath Deposition

Synthesis and Characterization of In2s3 Nanocrystalline Material for Photovoltaic Application

Influence of Bath Temperature on the Properties of In2S3 Films Grown by Chemical Bath Deposition

Effect of C4H6O6 Concentration on the Properties of SnS Thin Films for Solar Cell Applications

Optical Properties of Thermally Evaporated in 2 S 3 Thin Films Measured Using Photoacoustic Spectroscopy

The low temperature pyrolysis preparation of In2S3 thin film and its application in Sb2S3 thin film solar cells

Studies on chemical bath deposited SnS2 films for Cd-free thin film solar cells

Optimizing Photovoltaic Efficiency Through Di-Indium Tri-Selenide Thin Film Solar Cells

Simple thermal vapor deposition process for and characterization of n-type indium oxysulfide thin films

Synthesis and Physical Behaviour of In2S3 Films

Antimony sulfide thin films in chemically deposited thin film photovoltaic cells

Solution-processed In2S3 nanosheet arrays for CuInS2 thin film solar cells

Synthesis and characterization of In 2 S 3 : Na thin films prepared by vacuum thermal evaporation technique for photovoltaic applications

Growth and Characterization of p-Type and n-Type Sb2Se3 for Use in Thin-Film Photovoltaic Solar Cell Devices

Chemical bath deposition of Sb2S3 thin films using the mixing solution of SbCl3 and sodium citrate as a novel Sb source for assembling efficient solar cells

Self‐Regulated Growth of Large‐Grain Sb2S3 Thin Films for High‐Efficiency Solar Cells

Growth of copper indium diselenide ternary thin films (CuInSe2) for solar cells: Optimization of electrodeposition potential and pH parameters