Abstract:Hydrate surface wettability is a fundamental aspect to better understand agglomeration present in oil bearing petroleum pipelines. Coupling these measurements with hydrate film growth gives further information on kinetic effects that may also be present from natural surfactants in different oils. In situ measurements of wettability (quantified by the contact angle) and film growth rates were performed on cyclopentane hydrate surfaces at atmospheric pressure and subcooling of 4 °C. Contact angle and film growth results were obtained for the baseline system (pure cyclopentane), one model oil, and seventeen natural oils (diluted to 0.02 vol% in cyclopentane). Results showed a wide variety of contact angles and film growth values where higher asphaltene contents in the oils corresponded to higher contact angles and lower film growth rates, thought to be from better alignment of natural surfactant molecules at the hydrate/hydrocarbon interface. It was also shown for select oils that increasing the oil concentration in the cyclopentane increases the contact angle and decreases the film growth rate compared to the baseline system. For select oils that had higher contact angles, increasing the water content of the system decreases their contact angle and film growth compared to the baseline system. Isolating different oil fractions for select oils also shows which fractions tend to play a larger role in wettability behavior. Typically, the fractions with more surface active components (asphaltene and resins) are shown to contribute to the higher contact angle and slower film growth rates for select oils. Evidence of the competition between film growth and capillary suction of water into the hydrate has been shown, and a mechanistic breakdown of three different transient scenarios has been proposed. Each of these observed interfacial behaviors gives information on what can be expected from larger scale phenomena, including hydrate agglomeration, with very small oil samples.

EQUILIBRIUM DATA OF CYCLOPENTANE HYDRATE

Gas Hydrate Phase Equilibrium Data of Cyclohexane and Cyclopentane

Measurement And Modeling Of The High-Pressure Phase Behavior Of The Carbon Dioxide Plus Propene Oxide Binary System

Investigation of hydrate formation by synthetic ternary gas mixture with cyclopentane(C5H10)

Hydrate Phase Equilibria of Ternary Gas Mixtures with Tetrabutylammonium Bromide and Cyclopentane

Selection of Entrainer and Vapour–Liquid Equilibrium Data for Cyclohexene and Cyclohexane Near-Boiling Systems at 101.3 kPa

The Relationship between Thermal Characteristics and Microstructure/Composition of Carbon Dioxide Hydrate in the Presence of Cyclopentane

Study of Vapor–hydrate Two-Phase Equilibria

Experimental investigation on the synergistic influence of tetra-n-butyl ammonium bromide(TBAB) and cyclopentane(CP) in hydrate-based gas separation

Vapor-hydrate Phases Equilibrium of (CH4+C2H6) and (CH4+C2H4) Systems

Vapor-Liquid equilibria of the ternary system of methane + n-decane + n-octacosane at high pressures

Study on the Phase Equilibrium of Hydrate Separation Processes for Methane-Ethane-H2O Systems

Isobaric Vapor–Liquid Equilibria of Binary Systems Containing Cyclohexane for the Separation of Phenolic Compounds from Biomass Fast Pyrolysis Oils

Phase Equilibrium of Hydrogen Clathrate Hydrates with Propylene Oxide and 1,2-Epoxycyclopentane

Volumetric Properties of Binary Systems of Straight-chain Alkanes+JP-10

Experimental Preparatory of Gas Hydrate Storage

N‐pentane and N‐hexane As Coguests in Structure‐H Hydrates in Mixtures of 2,2‐dimethylbutane and Methane

Vapor-hydrate phases equilibrium of (CH 4 +C 2 H 6 ) and (CH 4 +C 2 H 4 ) systems

Molecular Simulation of the Effects of Cyclic Organic Compounds on the Stability of Lccbm Hydrates

Cyclopentane hydrate wettability measurements used to evaluate the efficacy of oil natural surfactants using ultra-low volume samples

PHASE EQUILIBRIUM CALCULATION FOR REFRIGERANT SIMPLE GAS HYDRATES