Abstract:We report on the construction and upgrade of a Lawrence Berkeley National Laboratory Cosmic Muons Detector. We modify the electronics and mechanics to achieve a highly efficient gamma-ray and cosmic-ray detector. Each detector module uses a one-inch-thick scintillator, attached to a photomultiplier tube (PMT) and mounted on a solid aluminum frame. The detector uses scintillation to transform passing radiation into detectable photons that are guided toward a photocathode surface of the PMT, triggering the release of photoelectrons that are then amplified to yield measurable electronic signals. The modules were connected to an electronics section that compared the signals from the two PMTs and logically determined if they were coincidence events. A data-collection device was added for faster and prolonged count rates. A cobalt-60, which produced two gamma rays and a beta particle has been used as a calibration source. To investigate the isotropic behavior of radiation, two detection modules were adjusted to different angles of rotation with respect to each other, and the coincidence counts were measured. The coincidence counts from the modules set at various angles were consistent throughout the angular spectrum, and only lead shielding visibly reduced the number of counts from the radioactive source. The inverse-square-law behavior of radiation has also been considered. The results were such that the number of counts decreased as a function of increasing distance from the source. Furthermore, positioning the detector to point toward the sky in different orientations, we measured cosmic ray muon flux as the angle from the vertical was decreased. In doing so, we scanned different patches of the atmosphere. For the optimum operation during the detection phase, we plateaued both PMTs to single out their best operating gain voltage while eliminating false background noise signals.

CONSTRUCTION OF MULTI-NEUTRON CORRELATION SPECTROMETER (MUNCOS) AT PEKING UNIVERSITY

Construction and Calibration of the Multi-Neutron Correlation Spectrometer at Peking University

Performance Study of the Multi-purpose Time Projection Chamber (MTPC) Using a Four-Component Alpha Source

Design of a Μsr Spectrometer with Ultrahigh Arrays at China Spallation Neutron Source

Muon Flux Measurement at China Jinping Underground Laboratory

Design of a $μ$SR spectrometer with ultrahigh arrays at China Spallation Neutron Source

Monte Carlo Simulation of the Property of A Scintillation Bar in the Multi-Neutron Correlation Spectrometer

Performance Calibration Using Cosmic Rays for the Multi-Neutron Correlation Spectrometer

Optimization of detector placements in reduction of multiple counts for mu SR measurements at China Spallation Neutron Source

A multiplex readout method for position sensitive boron coated straw neutron detector

Accelerator Mass Spectrometry at Peking University: Experiments and Progress

Design of the First Μsr Spectrometer at China Spallation Neutron Source

Performances of a Β-Delayed Neutron Detection Array at Peking University

Measurement of Muon-induced Neutron Production at China Jinping Underground Laboratory

Developments of a 2D position sensitive neutron detector

Study of Cosmogenic Neutron Production for ∼360 GeV Muons

Development of L-Bent Positron Detectors for Μ SR Applications at China Spallation Neutron Source

Analysis of Gamma Rays and Cosmic Muons with a Single Detector

Monte Carlo simulation of a Bonner sphere spectrometer for application to the determination of neutron field in the Experimental Advanced Superconducting Tokamak experimental hall

Neutronic design and simulated performance of Peking University Neutron Imaging Facility (PKUNIFTY)

Study of neutron production for 360 GeV cosmic muons