Aqueous Colloidal Injection Molding Of Ceramics Based On Gelation

Yong Huang,Jinlong Yang

DOI: https://doi.org/10.1007/978-981-15-1872-0_1

2011-01-01

Abstract:In this chapter, an aqueous colloidal injection molding of ceramics (CIMC) which is based on gelation of monomer polymerization, like a reactive injection molding of double-slurry of polyester, is discussed systematically. The solidification mechanism is based on gelation of monomer polymerization. It was found that pressure can induce the polymerization of monomer. The gelation time can be effectively controlled by temperature and pressure. The testing equipment of gel point was developed and used to test gel reaction of monomer in suspension under different pressures. A machine for ceramic colloidal injection molding was developed. The copper was proved to accelerate the polymerization of monomer. Therefore, the copper parts are forbidden for use in a CIMC machine.