Abstract:With the advancement of semiconductor manufacturing technology, thin film structures were widely used in MEMS devices. These films played critical roles in providing support, reinforcement, and insulation in MEMS devices. However, due to their microscopic dimensions, the sensitivity of their parameters and performance to thermal stress increased significantly. In this study, a Pirani gauge sample with a multilayer thin film structure was designed and fabricated. Based on this sample, finite element modeling analysis and thermal stress experiments were conducted. The finite element modeling analysis employed a combination of steady-state and transient methods to simulate the deformation and stress distribution of the device at room temperature (25 °C), low temperature (−55 °C), and high temperature (125 °C). The thermal stress test involved placing the sample in a temperature cycling chamber for temperature cycling tests. After the tests, the resonant frequency and surface deformation of the device were measured to quantitatively evaluate the impact of thermal stress on the deformation and resonant frequency parameters of the device. After the experiments, it was found that the clamped-end beams made of Pt were a stress concentration area. Additionally, the repetitive thermal load caused the cantilever beam to move cyclically in the Z direction. This movement altered the deformation of the film and the resonant frequency. The suspended film exhibited concavity, and the overall trend of the resonant frequency was downward. Over time, this could even lead to the fracture of the clamped-end beams. The variation of mechanical parameters derived from finite element simulations and experiments provided an important reference value for device design improvement and played a crucial role in enhancing the reliability of thin film devices.

Investigation of Stress in MEMS Sensor Device Due to Hygroscopic and Viscoelastic Behavior of Molding Compound

Effects of Hygrothermal Aging and Cyclic Compressive Loading on the Mechanical and Electrical Properties of Conductive Composites

Thermal stress of MOEMS Accelerometers Based on Grating Interferometric cavity

Packaging Effect on MEMS Pressure Sensor Performance

Investigation of Potting-Adhesive-Induced Thermal Stress in MEMS Pressure Sensor

Evaluation of Die Stress in MEMS Packaging: Experimental and Theoretical Approaches

Moisture Diffusion and Hygroscopic Swelling of Adhesives in Electronics Packaging

Hygrothermal Stress Analysis for a Micro-Camera Module under the Moisture Sensitivity Level One

Integrated Stress Sensors for Humidity Performance Drift Analysis and Compensation in Inertial Measurement Units

A Method to Evaluate the Influence of Different Substrate on Stress Mismatch Induced Deformation in MEMS Accelerometer

Investigation on the effect of the packaging-induced stress on the reliability of a MEMS sensor package

Recent Efforts in Modelling Combined Rate, Size and Thermal Effects on Single Crystal Strength

Variation of MEMS Thin Film Device Parameters under the Influence of Thermal Stresses

A Nondestructive Raman Spectra Stress 2D Analysis for the Pressure Sensor Sensitive Silicon Membrane

Analysis Of The Packaging Stresses In Monolithic Multi-Sensor

Evaluation of performance of magneto-electro-elastic sensor subjected to thermal-moisture coupled load via CS-FEM

Measurement of Thermal Stress in Cob Packaging Structures

Accurate Assessment of Packaging Stress Effects on MEMS Sensors by Measurement and Sensor–Package Interaction Simulations

Study on Package Thermal Stress of Multi-ranged Micro-accelerometer

MEMS Die Warpage During Curing of Die Attach Material

A Method to Measure Residual Stress of Liquid Molding Compound by In-Situ Characterizations