Abstract:Surface pollution deposition in a high voltage surface can reduce the surface flashover voltage, which is considered to be a serious accident in the transmission of electric power for the high conductivity of pollution in wet weather, such as rain or fog. Accordingly, a rapid and accurate online pollution detection method is of great importance for monitoring the safe status of transmission lines. Usually, to detect the equivalent salt deposit density (ESDD) and non-soluble deposit density (NSDD), the pollution should be collected when power cut off and bring back to lab, time-consuming, low accuracy and unable to meet the online detection. Laser-induced breakdown spectroscopy (LIBS) shows the highest potential for achieving online pollution detection, but its application in high voltage electrical engineering has only just begun to be examined. In this study, a LIBS method for quantitatively detecting the compositions of pollutions on the insulators was investigated, and the spectral characteristics of a natural pollution sample were examined. The energy spectra and LIBS analysis results were compared. LIBS was shown to detect pollution elements that were not detected by conventional energy spectroscopy and had an improved capacity to determine pollution composition. Furthermore, the effects of parameters, such as laser energy intensity and delay time, were investigated for artificial pollutions. Increasing the laser energy intensity and selecting a suitable delay time could enhance the precision and relative spectral intensities of the elements. Additionally, reducing the particle size and increasing the density achieved the same results.

Study of the Ac Arc Discharge Characteristics over Polluted Insulation Surface Using Optical Emission Spectroscopy

Study on the Typical Optical Emission Spectrograms of AC Arc Discharge over the Polluted Insulation Surface

Optical Diagnostic Characterization of the Local Arc on Contaminated Insulation Surface at Low Pressure

Study of DC Arc Characteristics on Polluted Silicon Rubber Surface

Effect Of Air Pressure On The Characteristics Of Ac Partial Arcs Over The Polluted Insulation Surface

Calculation of DC and AC Flashover Voltage of Polluted Insulators

Pollution Flashover Calculation Model Based on Characteristics of AC Partial Arc on Top and Bottom Wet-Polluted Dielectric Surfaces

Mapping Relation of Leakage Currents of Polluted Insulators and Discharge Arc Area

Modeling of AC Arc Discharge on Insulators in Consideration of Arc Characteristic Differences Between Partial Arcs on Top and Bottom Wet-polluted Dielectric Surfaces

Influence of Contaminated Location on Streamer Discharge

Influence of Pollution on Surface Streamer Discharge

Effect of Arcing on DC Flashover Performance of Contaminated Porcelain Insulators for Various Suspension Patterns at High Altitudes

Research on Pollution Flashover Characteristics of Hydrophilic Surface under Combined AC-DC Voltage

Insulator Contamination Analysis Based on Laser-Induced Breakdown Spectroscopy

Study on pollution accumulation characteristics of typical insulators

Study on the Polluted Regularity of Insulators Quantitatively Described by Partial Surface Conductivity

A Study on Streamer Discharge Characteristics along Contamination Insulator Surface

Analysis of Pollution in High Voltage Insulators Via Laser-Induced Breakdown Spectroscopy.

Study of the flashover process on ice-covered insulator string

Effect of Vertical Electric Field Components on the Local Arc Development along Contaminated Surfaces

Experimental research on pollution flashover voltage and leakage current characteristics of naturally polluted insulators