Abstract:III-Nitride-based nanowire LEDs have shown high internal quantum efficiency and stable light emission over a wide current range to enable white phosphor-free white-light emission. The structures provide a unique advantage for flexible electronics where the out-of-plane three-dimensional nanowires are invariant to applied bending. Testing this concept, InGaN dot-in-wire light-emitting diodes on sapphire substrates were transferred onto flexible polyethylene terephthalate (PET) substrates using a bonding and laser-liftoff process. In0.15Ga0.85N nanowire blue LEDs were grown on sapphire substrates having Ni/Au contacts applied to the top p-doped region and a lateral insulating polyimide layer applied between the nanowires. The nanowire structures were then bonded onto a transfer wafer and separated from its sapphire growth substrate by laser-liftoff (LLO) using a 266 nm KrF laser. A double-transfer technique, where the inverted LED structures were then transferred and bonded onto the PET with a silver-based adhesive that formed the final bottom contact. The LEDs before and after the transfer process did not show measurable degradation in the I-V and optical characteristics. The 425 nm luminescence peak was found to remain constant during applied mechanical strain on the flexible substrate suggesting the nanowire LEDs did not experience any plane-strain during bending. A constant 2.5 V turn-on voltage, and a forward current of 0.4 mA at 4 V was measured under concave and convex bending. Atomic force and scanning electron microscopy characterization will also be shown of the nanowire device before and after double transfer as well as numerical simulation of the mechanical motion of the nanowire structures during bending.

Fully Bendable Polymer Light Emitting Devices with Carbon Nanotubes As Cathode and Anode

Highly Flexible Polymer Light-Emitting Devices Using Carbon Nanotubes As Both Anodes and Cathodes

All carbon nanotube based flexible field emission devices prepared through a film transfer method

Flexible Light-Emitting Devices Based on Chirality-Sorted Semiconducting Carbon Nanotube Films.

Carbon Nanotube Arrays on Flexible Substrate and Their Field Emission Characteristics

Synthesis and Characterization of Carbon Nanotube Grown on Flexible and Conducting Carbon Fiber Sheet for Field Emitter

Flexible electroluminescent fiber fabricated from coaxially wound carbon nanotube sheets

Flat-panel luminescent lamp using carbon nanotube cathodes

Lateral Field Emitters Fabricated Using Carbon Nanotubes

Electrical and Optical Properties of Flexible Nanowire Blue Light-Emitting Diodes under Mechanical Bending (conference Presentation)

Transparent Flexible Organic Thin-Film Transistors That Use Printed Single-Walled Carbon Nanotube Electrodes

Flexible Field Emitter Made of Carbon Nanotubes Microwave Welded Onto Polymer Substrates

Highly flexible light emitting diodes based on a quantum dots-polymer composite emitting layer

Flexible electroluminescent device based on ZnS:Cu-polyurethane composite and silver nanowires

Highly Flexible CsPbI3 Perovskite Nanocrystal Light‐Emitting Diodes

Dual-Function Optoelectronic Polymer Device for Photoelectric Conversion and Electroluminescence

Nanocarbon Paper: Flexible, High Temperature, Planar Lighting with Large Scale Printable Nanocarbon Paper (adv. Mater. 23/2016).

Highly transparent, low sheet resistance and stable Tannic acid modified-SWCNT/AgNW double-layer conductive network for organic light emitting diodes

Cold linear cathodes with carbon nanotube emitters and their application in luminescent tubes

Bilayer Nanocarbon Heterojunction for Full-Solution Processed Flexible All-Carbon Visible Photodetector

High-Performance Copper Nanowire Electrode for Efficient Flexible Organic Light-Emitting Diode