Abstract:The spectral and laser output characteristics of Cr:ZnSe single crystals optically polished at four different lengths of 2, 3, 5, and 10 mm combined with or without antireflection (AR) coatings were investigated under pulse and continuous wave (CW) laser diode excitation at the wavelength of ~1.7 μm. The absorption and fluorescence spectra of Cr 2+ ions were measured at room temperature. Optimization of laser system efficiency was performed step-by-step in dependence on the active length of the crystal sample, output coupler reflectivity, the duration of the pump pulse, and the repetition rate. For a given 1 : 1 transferring optics, a 3-mm thick AR-coated Cr:ZnSe crystal was chosen as optimal in pulse mode of operation: The ~10% higher maximum slope efficiency of ~39% with respect to optical-to-optical power conversion was obtained with the 3-mm thick AR-coated sample compared to the uncoated one. The laser system was characterized by an optimal repetition rate of 10 Hz and a pump pulse duration of 20 ms selected for its best efficiency performance. In CW mode, better results were observed with a thicker sample (5 mm, AR-coated). Specifically, the output power of ~2.7 W at the wavelength of ~2.4 μm with a slope efficiency of ~24% was obtained. In this case, the M 2 beam parameter was measured as low as ~1.1 ± 0.1. Using a 0.8 mm thick MgF 2 birefringent filter plate, the laser oscillations were continuously tunable in the range of ~2.1–2.7 μm within narrow spectral linewidths (5–10 nm FWHM) and a Gaussian beam profile in both the pulse and CW regimes.

Specular Reflection Enhancement and Reduction from the Surface of a Photorefractive Crystal in the Presence of a “pump” Beam

Total Reflection Enhancement in an Incoherent-Gain Prism Coupler Towards Optical Switches and Photonic Transistors

Coupled Optical and Electronic Simulations of Electrically Pumped Photonic-Crystal-Based Leds

Influence of Bragg Reflection of Chirped Tilted Fiber Bragg Grating on Raman Suppression in High-Power Tandem Pumping Fiber Amplifiers.

Single Beam Transmission in a Photorefractive Polymer Composite

Theory of a “stimulated photorefractive backscattering and four-wave mixing” self-pumped phase conjugator

Investigations on Formation of Mutually Pumped Phase Conjugation with a New Configuration Using BaTiO3:Ce Crystal.

Post-trimming of photonic crystal nanobeam cavities by controlled electron beam exposure.

Reflection of focused beams from opal photonic crystals

Optimization of Pump Pulse Duration and Cr:ZnSe Crystal Length for Efficient Generation of Tunable Mid-IR Laser Radiation Pumped by Laser Diode at Room Temperature

Modulation transfer function of photorefractive phase conjugators for two mutually coherent input beams

Enhanced Reflection Via Phase Compensation From Anomalous Dispersion In Atomic Vapor

Enhanced Self-Pumped Phase Conjugation from 45 Degrees-Cut Rh : Batio3

Compression and Broadening of Phase-Conjugate Pulses in Photorefractive Self-Pumped Phase Conjugators

Bidirectional Photorefractive Ring Resonator Pumped by A Single Beam

Enhanced Photorefractivity In A Polymer/Nanocrystal Composite Photorefractive Device At Telecommunication Wavelength

Beam Suppression and Focusing in Multi-Plate Crystal Cavity with Compound Refractive Lenses

Ring Self-Pumped Phase Conjugator with High-Speed Modulated Incident Beam

Pump-probe studies of resonantly saturated selective reflection from high-density rubidium vapor

All-fiber laser pump reflector based on a fs-written VBG

Reflection-grating Based Photorefractive Phase Conjugator and Ring Resonator