Abstract:Compared to cross-linked polyethylene, polypropylene has a thermoplastic property and the advantage of recycling. However, the poor impact resistance at low temperature and the corresponding space charge problem restrict the application of polypropylene with the extruded high voltage direct current (HVDC) cable. Sufficient introduction of the β form of the polypropylene crystal can significantly improve impact resistance at low temperatures. Although it has been widely applied in insulation engineering, the effect of β-crystal on the space charge characteristics of polypropylene has rarely been researched until now. In this paper, a rare earth nucleating agent of β-crystal is employed to modify the performance of polypropylene to investigate the effects of nucleating agent content on β-crystalline, mechanical relaxation, trap, and space charge characteristics of polypropylene. The results of differential scanning calorimeter (DSC) and X-ray diffraction (XRD) tests indicate that the relative content of β-crystal in modified polypropylene increases gradually with the increasing concentration of the nucleating agent, approaching 43.5% when the nucleating agent content has been raised to 0.2 wt %, suggesting appreciable efficiency of the nucleating agent utilized in our research. Scanning electron microscopy (SEM) is utilized to characterize the morphology of β-crystal spherulites, which illustrates that the β-spherulites are in bunchy shape, and the lamellar crystals are parallel to each other without an obvious boundary between them. The results of the space charge test demonstrate that the modified polypropylene can substantially suppress space charge accumulation, which is attributed to an increment of β-crystal content by adopting a rare earth nucleating agent. It is indicated from dynamic mechanical analysis (DMA) measurements that the enhancement of β-crystalline in modified polypropylene can distinctly increase and decrease the β and α relaxation losses, respectively, which proves that the defects in β-crystal and amorphous regions are reduced and increased respectively. Thermally stimulated depolarization current tests further confirm that the number of traps caused by defects in the β-form of polypropylene crystal declines definitely, which dominantly accounts for the suppression of space charge accumulation.

A Remarkable Suppression on Space Charge in Isotatic Polypropylene by Inducing the Β-Crystal Formation

Influence of Crystalline Phase on Conduction Current and Space Charge in Isotactic Polypropylene

Space Charge Characteristics of Polypropylene Modified by Rare Earth Nucleating Agent for β Crystallization

Investigation on the Effects of MXene and Β-Nucleating Agent on the Crystallization Behavior of Isotactic Polypropylene

Effect of Thermally Induced Self-assembly of Β Nucleating Agents on Space Charge in Isotactic Polypropylene

Crystalline Modification and Its Effects on Dielectric Breakdown Strength and Space Charge Behavior in Isotactic Polypropylene

Direct Correlation Between Charge Evolution And Crystalline Structure In Isotactic Polypropylene

Effects of Temperature-Induced Crystalline Phase Transition on the Space Charge Characteristics of Isotactic Polypropylene

Effect of Epitaxial Crystallization on Packet-Like Space Charge Characteristics in Low-Density Polyethylene under Multi-Field Coupling Conditions

Influence of microstructure on space charges of polypropylene

Effect of Annealing Rate on Low-Temperature Impact Strength and Space Charge Characteristics of Isotactic Polypropylene

STUDY ON CRYSTALLIZATION BEHAVIOR OF ISOTACTIC POLYPROPYLENE PRODUCED BY SUPERCRITICAL POLYMERIZATION

Crystallization Behavior and Morphological Development of Isotactic Polypropylene with an Aryl Amide Derivative As Β-Form Nucleating Agent Part B Polymer Physics

Effect Of Beta-Nucleating Agents On Crystallization And Melting Behavior Of Isotactic Polypropylene

The Effects Of Crystallization Condition On The Microstructure And Thermal Stability Of Istactic Polypropylene Nucleated By Beta-Form Nucleating Agent

Effects of Crystallinity on the Space Charge Properties of Polyethylene

Dependence of β-crystal formation of isotactic polypropylene on crystallization conditions

Large Improvement in Trap Level and Space Charge Distribution of Polypropylene by Enhancing the Crystalline − Amorphous Interface Effect in Blends

Concentration Effect of a Bis-amide Nucleating Agent on the Shear-Induced Crystallization Behavior of Isotactic Polypropylene

Influence of compounded α/β-nucleating agents on the crystallization behavior and mechanical properties of isotactic polypropylene

Influence of a Novel Β‐nucleating Agent on the Structure, Morphology, and Nonisothermal Crystallization Behavior of Isotactic Polypropylene