Abstract:In this study, one of the commonly used MXene (Ti3C2Tx) and β nucleated isotactic polypropylene (β-iPP)/MXene composites of different compositions were fabricated. The effects of MXene on non-isothermal crystallization and polymorphic behavior of β-iPP/MXene composites were comparatively studied. The non-isothermal crystallization kinetics indicates that for all samples, the lower cooling rates promote composites to crystallize at higher temperatures. When MXene and β-Nucleating agent (β-NA) are added separately, the crystallization temperature of composites shifts towards higher temperatures at all cooling rates. When MXene and β-NA are added simultaneously, the composite shows different cooling rate dependence, and the effects of improving crystallization temperatures is more obvious under rapid cooling. The activation energy of four samples iPP, iPP/MXene, iPP/β-NA, and iPP/MXene/β-NA were −167.5, −185.5, −233.8, and −218.1 kJ/mol respectively, which agree with the variation tendency of crystallization temperatures. The polymorphic behavior analysis obtained from Differential Scanning calorimetry (DSC) is affected by two factors: the ability to form β-crystals and the thermal stability of β-crystals. Because β-crystals tend to recrystallize to α-crystals below a critical temperature, to eliminate the effect of β-α recrystallization, the melting curves at end temperatures Tend = 50 °C and Tend = 100 °C are comparatively studied. The results show that more thermally unstable β-crystals would participate in β-α recrystallization with higher cooling rates. Moreover, thermal stability of β-crystals is improved by adding MXene. To further verify these findings, samples of three different thermal conditions were synthesized and analyzed by DSC, X-Ray Diffraction (XRD), and Polarized Light Optical Microscopy (PLOM), and the results were consistent with the above findings. New understandings of synthesizing β-iPP/MXene composites with adjustable morphologies and polymorphic behavior were proposed.

Concentration Effect of a Bis-amide Nucleating Agent on the Shear-Induced Crystallization Behavior of Isotactic Polypropylene

Investigation on the Effects of MXene and Β-Nucleating Agent on the Crystallization Behavior of Isotactic Polypropylene

Exploring the Effects of MXene on Nonisothermal Crystallization and Melting Behavior of Β-Nucleated Isotactic Polypropylene

Crystallization Behavior and Morphological Development of Isotactic Polypropylene with an Aryl Amide Derivative As Β-Form Nucleating Agent Part B Polymer Physics

Study of the Assembled Morphology of Aryl Amide Derivative and Its Influence on the Nonisothermal Crystallizations of Isotactic Polypropylene

Accelerating Shear-Induced Crystallization and Enhancing Crystal Orientation of Isotactic-Polypropylene Via Nucleating Agent Self-Assembly

STUDY ON CRYSTALLIZATION BEHAVIOR OF ISOTACTIC POLYPROPYLENE PRODUCED BY SUPERCRITICAL POLYMERIZATION

Influence of compounded α/β-nucleating agents on the crystallization behavior and mechanical properties of isotactic polypropylene

More Dominant Shear Flow Effect Assisted by Added Carbon Nanotubes on Crystallization Kinetics of Isotactic Polypropylene in Nanocomposites

Synthesis and Effect Ofn,n'-Diphenylterephthalamide on Crystallization of Isotactic Polypropylene

Influence of N,N,N′,N′-tetraalkyl terephthalamide on isothermal crystallization kinetics and morphology evolution of polypropylene

Temperature‐dependent Selective Crystallization Behavior of Isotactic Polypropylene with a Β‐nucleating Agent

Influence of the Amount of Salts of Rosin Acid on the Nonisothermal Crystallization, Morphology, and Properties of Isotactic Polypropylene

The Effects Of Crystallization Condition On The Microstructure And Thermal Stability Of Istactic Polypropylene Nucleated By Beta-Form Nucleating Agent

Effect of Final Heating Temperature on Crystallization of Isotactic Polypropylene Nucleated with an Aryl Amide Derivative As Β -Form Nucleating Agent

Dependence of β-crystal formation of isotactic polypropylene on crystallization conditions

Toward a More Comprehensive Understanding on the Structure Evolution and Assembly Formation of a Bisamide Nucleating Agent in Polypropylene Melt

Effect Of Beta-Nucleating Agents On Crystallization And Melting Behavior Of Isotactic Polypropylene

Application of an interpenetrating network model to the solid deformation of a quenched isotactic polypropylene film

Investigation of crystal habit of N,N′-dicyclohexylterephthalamide and its influence on the crystallization behavior of isotactic polypropylene

Effect of aromatic dihydrazide compounds on crystallization behavior and mechanical properties of isotactic polypropylene