Abstract:Structural Health Monitoring, Ahead of Print. Currently, spent nuclear fuel (SNF) from commercial nuclear power plants is stored in stainless-steel canisters for interim dry storage. To provide an inert environment, these canisters are backfilled with helium after vacuum drying. However, the helium environment may be contaminated during extended storage because of the material degradation. For example, the heavier fission gas xenon may be released from the fuel rods into the canister cavity should the fuel cladding be breached. Other gases such as air and water vapor may also be present as a result of leakage caused by chloride-induced stress corrosion cracking on the canister walls or by insufficient vacuum drying. Therefore, monitoring the gas composition can provide critical information about the health of SNF canisters. In this study, noninvasive testing was conducted on a 2/3-scaled SNF canister mock-up using acoustic sensing. Ultrasonic transducers were placed on the exterior surface of the canister to probe the gas composition. A dataset was collected by sealing the canister mock-up and introducing up to 1.53% argon or 1.29% air into the helium background gas. Three methods were used to detect changes in the gas composition: the time-of-flight (TOF) method, the differential method, and the autoencoder method. Results showed that the TOF method had sufficient resolution to detect abnormal gas concentrations of less than 1.0%. The differential method demonstrated a periodic in-phase and out-of-phase behavior between the benchmark (i.e., pure helium) and abnormal (i.e., with argon or air) state signals. The variational autoencoder (VAE) and the Wasserstein autoencoder (WAE) were trained on the benchmark data and were applied directly to the abnormal state data. It was found that both the unsupervised VAE and the WAE were able to distinguish the benchmark and abnormal states of the canister mock-up based on the reconstruction error.

Conformal Sensor Skin Approach to the Safety-Monitoring of H-2 Fuel Tanks

Embedded Capacitance Sensor Array For Structural Health Monitoring Of Pipeline Systems

Self-sensing Joints for In-Situ Structural Health Monitoring of Composite Pipes: A Piezoresistive Behavior-Based Method

Wireless Passive Sensor Technology through Electrically Conductive Media over an Acoustic Channel

Damage Detection And Leakage Alert Of Fiber Composite Wrapped Tank For High Pressure Hydrogen Storage

A Continuous Liquid-Level Sensor for Fuel Tanks Based on Surface Plasmon Resonance

Micro-Signals and Modal Potentials of Nonlinear Deep and Shallow Conical Shells

Real-Time Micro-Monitoring of Surface Temperature and Strain of Magnesium Hydrogen Tank through Self-Made Two-In-One Flexible High-Temperature Micro-Sensor

MEMS Based H2 Gas Sensors

Tilted Fiber Bragg Grating Sensor Using Chemical Plating of a Palladium Membrane for the Detection of Hydrogen Leakage

Acoustic sensing and autoencoder approach for abnormal gas detection in a spent nuclear fuel canister mock-up

Real-time microscopic monitoring of temperature and strain on the surface of magnesium hydrogen storage tank by high temperature resistant flexible integrated microsensor

High‐Sensitivity RFID Sensor for Structural Health Monitoring

Resonant sandwich-structured piezoelectric cantilever for volatile alcohol level monitoring

High-performance hydrogen gas sensor system based on transparent coaxial cylinder capacitive electrodes and a volumetric analysis technique

Hydrogen Sensor Based on Polymer-Filled Hollow Core Fiber with Pt-Loaded Wo3/Sio2 Coating

Flexible, self-healing and portable supramolecular visualization smart sensors for monitoring and quantifying structural damage

Pd Nanoparticle Film on a Polymer Substrate for Transparent and Flexible Hydrogen Sensors.

Study of a Fiber Optic Fabry-Perot Strain Sensor for Fuel Assembly Strain Detection

Ultra-Low-Power, Extremely Stable, Highly Linear-Response Thermal Conductivity Sensor Based on a Suspended Device with Single Bare Pt Nanowire

Metal-polymer hybrid chemiresistive sensor for low concentration fast hydrogen detection