Fabrication and Properties of High Performance YBa 2 Cu 3 O 7-Δ Radio Frequency SQUIDs with Step-Edge Josephson Junctions

Liu Zheng-Hao,Wei Yu-Ke,Wang Da,Zhang Chen,Ma Ping,Wang Yue
DOI: https://doi.org/10.1088/1674-1056/23/9/097401
2014-01-01
Chinese Physics B
Abstract:We describe the fabrication of high performance YBa2Cu3O7-δ(YBCO) radio frequency(RF) superconducting quantum interference devices(SQUIDs), which were prepared on 5 mm×5 mm LaAlO3(LAO) substrates by employing stepedge junctions(SEJs) and in flip-chip configuration with 12 mm×12 mm resonators. The step in the substrate was produced by Ar ion etching with step angles ranging from 47°to 61°, which is steep enough to ensure the formation of grain boundaries(GBs) at the step edges. The YBCO film was deposited using the pulsed laser deposition(PLD) technique with a film thickness half of the height of the substrate step. The inductance of the SQUID washer was designed to be about 157 pH.Under these circumstances, high performance YBCO RF SQUIDs were successfully fabricated with a typical flux-voltage transfer ratio of 83 mV/Φ0, a white flux noise of 29 μΦ0/(Hz) 1/2 , and the magnetic field sensitivity as high as 80 fT/(Hz) 1/2 .These devices have been applied in magnetocardiography and geological surveys.
What problem does this paper attempt to address?