Influence of Ce Doping on Microstructure of Zno Nanoparticles and Their Acetone Sensing Properties

F. M. Li,X. B. Li,S. Y. Ma,L. Chen,W. Q. Li,C. T. Zhu,X. L. Xu,Y. Chen,Y. F. Li,G. Lawson

DOI: https://doi.org/10.1016/j.jallcom.2015.07.251

IF: 6.2

2015-01-01

Journal of Alloys and Compounds

Abstract:Electrospinning technology was generally used to synthesis nanofiber, here we use it to fabricate pure ZnO nanoparticles (ZnO NPs) and Ce-doped (0.1 wt%, 0.8 wt%, 1.5 wt%) ZnO nanoparticles (ZnO:Ce NPs) via decrease the molecular weight of PVP in precursor liquid. Their microstructures were characterized by X-ray diffraction, scanning electron microscopy, Brunauer-Emmet-Teller and photoluminescence spectra. The results clearly indicated that the 0.8 wt% ZnO:Ce NPs shows smaller average grain size (70 nm) and a higher specific surface area (21.5 m(2)/g). The testing on gas sensing performance revealed that the 0.8 wt% ZnO:Ce NPs based sensor shows the highest response values and a well selectivity to acetone. The response and recovery time of ZnO NPs based sensors to 100 ppm acetone was about 13 and 7 s while these are about 10 and 9 s in ZnO:Ce NPs based sensors, respectively. These results demonstrated that the 0.8 wt% ZnO:Ce NPs based sensor can rapidly be detect and distinguish accurately acetone in ambient air. Moreover, the sensor shows good long-term stability and reproducibility of response. The sensing mechanism was also discussed and the results indicated that the gas diffusing channels and the electron depleted layer of the ZnO NPs based sensor was increased markedly after Ce-doped, which results in the response of the ZnO:Ce NPs based sensor increased. (C) 2015 Elsevier B.V. All rights reserved.