Superelasticity by Reversible Variants Reorientation in a Ni–Mn–Ga Microwire with Bamboo Grains

Z. L. Wang,P. Zheng,Z. H. Nie,Y. Ren,Y. D. Wang,P. Muellner,D. C. Dunand
DOI: https://doi.org/10.1016/j.actamat.2015.08.002
IF: 9.4
2015-01-01
Acta Materialia
Abstract:The link between microstructure and mechanical properties is investigated for a superelastic Ni–Mn–Ga microwire with 226μm diameter, created by solidification via the Taylor method. The wire, which consists of bamboo grains with tetragonal martensite matrix and coarse γ precipitates, exhibits fully reversible superelastic behavior up to 4% tensile strain. Upon multiple tensile load–unload cycles, reproducible stress fluctuations of ∼3MPa are measured on the loading superelastic stress plateau of ∼50MPa. During cycles at various temperatures spanning −70 to 55°C, the plateau stress decreases from 58 to 48MPa near linearly with increasing temperature. Based on in situ synchrotron X-ray diffraction measurements, we conclude that this superelastic behavior is due to reversible martensite variants reorientation (i.e., reversible twinning) with lattice rotation of ∼13°. The reproducible stress plateau fluctuations are assigned to reversible twinning at well-defined locations along the wire. The strain recovery during unloading is attributed to reverse twinning, driven by the internal stress generated on loading between the elastic γ precipitates and the twinning martensite matrix. The temperature dependence of the twining stress on loading is related to the change in tetragonality of the martensite, as measured by X-ray diffraction.
What problem does this paper attempt to address?