Abstract:Soft magnetic materials with high magnetic susceptibility in response to the influence of alternating magnetic fields, generate an inductive electric voltage in the receiving coil, the spectrum of which contains higher harmonics. This is due to the nonlinear dependence of magnetization on the magnetic field, and the amplitudes of higher harmonics make a significant contribution to the overall signal if an external field leads to magnetic saturation. Magnetic susceptibility and saturation field are largely determined by magnetoelastic interactions in amorphous ferromagnets, respectively, the amplitudes of higher harmonics should depend on external mechanical stresses. In this work, we study the processes of magnetization reversal in amorphous microwires of two compositions: Co 71 Fe 5 B 11 Si 10 Cr 3 and Co 66.6 Fe 4.28 B 11.51 Si 14.48 Ni 1.44 Mo 1.69 under the action of external tensile stresses. For the first composition, mechanical stresses exceeding a certain limit (higher than 350 MPa) lead to the transformation of the magnetic hysteresis from a bistable type to an inclined one. In this case, a sharp change of the harmonic spectrum is observed. In microwires of the second composition with an initially inclined loop, external stresses cause a monotonous increase in the slope of the hysteresis loop (a decrease in susceptibility). In this case, the amplitudes of higher harmonics change significantly at low stresses, lower than 100 MPa. The results were obtained by magnetization reversal of microwire samples using a system of flat coils, which demonstrates the potential of using these materials as wireless sensors of mechanical stresses with remote reading.

Strain-magnetization property of Ni-Mn-Ga (Co, Cu) microwires

Structural, Magnetic and Mechanical Properties of Oligocrystalline Ni-Mn-Ga Shape Memory Microwires

Microstructural Evolution of Ni–Mn–Ga Microwires During the Melt-Extraction Process

Effect of Chemical Ordering Annealing on Martensitic Transformation and Superelasticity in Polycrystalline Ni–Mn–Ga Microwires

Tunable Magnetocaloric Effect in Ni-Mn-Ga Microwires.

Evolution of the Magnetic Anisotropy and Magnetostriction in Co-based Amorphous Alloys Microwires Due to Current Annealing and Stress -Sensory Applications

Magnetic anisotropy and stress-magnetoimpedance (S-MI) in current-annealed Co-rich glass-coated microwires with positive magnetostriction

Relating Residual Stress and Microstructure to Mechanical and Giant Magneto-Impedance Properties in Cold-Drawn Co-based Amorphous Microwires

Temperature-stable magnetoimpedance (MI) of current-annealed Co-based amorphous microwires

Co-Based Magnetic Microwire and Field-Tunable Multifunctional Macro-Composites

Structure, Magnetic and Magnetocaloric Properties of Ni2MnGa Heusler Alloy Nanowires

Optimizing magnetoimpedance of amorphous microwires by nanocarbon-induced magnetic anisotropy

Stress-Induced Magnetic Hysteresis in Amorphous Microwires Probed by Microwave Giant Magnetoimpedance Measurements

Stress-Dependent Magnetization Processes in Cobalt-Based Amorphous Microwires

Stress tunable microwave absorption of ferromagnetic microwires for sensing applications

Ultra-wide-temperature-range superelasticity and intrinsic two-way shape memory effect in Co–Ni–Ga microwires

Optimization of magnetic properties and GMI effect of Thin Co-rich Microwires for GMI Microsensors

Giant Tensile Superelasticity Originating from Two-Step Phase Transformation in a Ni-Mn-Sn-Fe Magnetic Microwire

Ferromagnetic Microwires Enabled Polymer Composites for Sensing Applications

Correlation of Magnetic Domains, Microstructure and Gmi Effect of Joule-Annealed Melt-Extracted Co68.15fe4.35si12.25b13.75nb1cu0.5 Microwires for Double Functional Sensors

Tuning of magnetocaloric effect and optimization of scaling factor for Gd 55 Ni 10 Co 35 amorphous microwires