Abstract:R&D for a MW-class solid target composed of tungsten was undertaken to produce a pulsed intense neutron source for a future neutron scattering-facility. In order to solve the corrosion of tungsten, tungsten target blocks were clad with tantalum by means of HIP’ing, brazing and electrolytic coating in a molten salt bath. The applicability of the HIP’ing method was tested through fabricating target blocks for KENS (spallation neutron source at KEK). A further investigation to certify the optimum HIP conditions was made with the small punch test method. The results showed that the optimum temperature was 1500 °C at which the W/Ta interface gave the strongest fracture strength. In the case of the block with a hole for thermocouple, it was found that the fabrication preciseness of a straight hole and a tantalum sheath influenced the results. The development of a tungsten stainless-steel alloy was tried to produce a bare tungsten target, using techniques in powder metallurgy. Corrosion tests for various tungsten alloys were made while varying the water temperature and velocity. The mass loss of tungsten in very slow water at 180 °C was as low as 0.022 mg/y, but increased remarkably with water velocity. Simulation experiments for radiation damage to supplement the STIP-III experiments were made to investigate material hardening by hydrogen and helium, and microstructures irradiated by electrons. Both experiments showed consistent results on the order of the dislocation numbers and irradiation hardness among the different tungsten materials. Thermal-hydraulic designs were made for two types of solid target system of tungsten: slab and rod geometry as a function of the proton beam power. The neutronic performance of a solid target system was compared with that of mercury target based on Monte Carlo calculations by using the MCNP code.

Neutron Production for 250 MeV Protons Bombarding on Thick Grain-Made Tungsten Target

Cross sections for the production of radionuclides induced in W targets by high energy carbon ions and protons

Productions of high energy neutrons by interactions between deuteron beam and thick target

Neutron Yields of Thick Be Target Bombarded with Low Energy Deuterons

The Energy Deposition of the Spallation Neutron Target

Measurement of Neutron Yield of ~9be(d,n) Reaction with Thick Target

Inelastic Collision Effects of High-Energy Neutrons in Tungsten Materials

R&D of a MW-class Solid-Target for a Spallation Neutron Source

Study of Properties of the Neutron Production Target Induced from 150-Mev Incident Proton Energy for the China Ads

Comparison of Photoneutron Yields in Tungsten Calculated by MCNPX Using Different Photonuclear Cross-Section Data for Typical Radiation Therapy Energies

Calculation of photoneutrons produced in the targets of electron linear accelerators for radiography and radiotherapy applications

Production Cross Sections of 102mrh and 108mag in Proton Bombed Natpb Target with 400 MeV Energy

Measurement of Neutron Yield of 9 Be(d,n)Reaction with Thick Target

Production of heavy neutron-rich nuclei with radioactive beams in multinucleon transfer reactions

Study On The Parameters Of The Lead Spallation Target

A Spherical Shell Target Scheme for Laser-Driven Neutron Sources

Study of Neutron Generation from Relativistic Heavy Ion Interactions

Problem of the spallation neutron production source related to accelerator-driven systems

Evaluation of Nuclear Activation of Tungsten Plates for Future Modeling of a Medical Accelerator

Production of High-Energy Neutron Beam from Deuteron Breakup

Dependence of neutron rate production with accelerator beam profile and energy range in an ADS-TRIGA RC1 reactor