Abstract:The relationship between the piezoelectric properties and the structure/microstructure for 0.05Bi(Mg2/3Nb1/3)O-3-(0.95-x)BaTiO3-xBiFeO(3) (BBFT, x=0.55, 0.60, 0.63, 0.65, 0.70, and 0.75) ceramics has been investigated. Scanning electron microscopy revealed a homogeneous microstructure for x<0.75 but there was evidence of a core-shell cation distribution for x=0.75 which could be suppressed in part through quenching from the sintering temperature. X-ray diffraction (XRD) suggested a gradual structural transition from pseudocubic to rhombohedral for 0.63<x<0.70, characterized by the coexistence of phases. The temperature dependence of relative permittivity, polarization-electric field hysteresis loops, bipolar strain-electric field curves revealed that BBFT transformed from relaxor-like to ferroelectric behavior with an increase in x, consistent with changes in the phase assemblage and domain structure. The largest strain was 0.41% for x=0.63 at 10 kV/mm. The largest effective piezoelectric coefficient (d(33)(*)) was 544 pm/V for x=0.63 at 5 kV/mm but the largest Berlincourt d(33) (148 pC/N) was obtained for x=0.70. We propose that d(33)(*) is optimized at the point of crossover from relaxor to ferroelectric which facilitates a macroscopic field induced transition to a ferroelectric state but that d(33) is optimized in the ferroelectric, rhombohedral phase. Unipolar strain was measured as a function of temperature for x=0.63 with strains of 0.30% achieved at 175 degrees C, accompanied by a significant decrease in hysteresis with respect to room temperature measurements. The potential for BBFT compositions to be used as high strain actuators is demonstrated by the fabrication of a prototype multilayer which achieved 3 mu m displacement at 150 degrees C.

Flexure Mode Flexoelectric Piezoelectric Composites

FLEXOELECTRIC COMPOSITE — A NEW PROSPECT FOR LEAD-FREE PIEZOELECTRICS

Experimental studies of the converse flexoelectric effect induced by inhomogeneous electric field in a barium strontium titanate composition

Flexoelectric Sensing Using a Multilayered Barium Strontium Titanate Structure

Size-dependent electromechanical properties in piezoelectric superlattices due to flexoelectric effect

Giant Flexoelectricity in Ba0.6sr0.4tio3/Ni0.8zn0.2fe2o4 Composite

Giant Piezoelectric Response in Piezoelectric/dielectric Superlattices Due to Flexoelectric Effect

TUNING THE RESONANT FREQUENCIES OF FLEXURE MODE FLEXOELECTRIC PIEZOELECTRIC COMPOSITES

Ultrahigh Piezoelectric Response Obtained by Artificially Generating a Large Internal Bias Field in BiFeO3–BaTiO3 Lead‐Free Ceramics

Flexoelectricity in barium strontium titanate thin film

Enhanced electric field-induced strain performance in 0-3 composite ceramics by strain and polarization coupling

Flexoelectricity in Compositionally Graded Ba1−xSrxTiO3 Ceramics

Flexoelectric Materials And Structures For M/Nems

Enhanced flexoelectricity through residual ferroelectricity in barium strontium titanate

Pure Low-Frequency Flexural Mode Of [011](C) Poled Relaxor-Pbtio3 Single Crystals Excited By K(32) Mode

Converse flexoelectricity with relative permittivity gradient

Compositional Heterogeneity Enhancing the Flexoelectric Response of BaTiO3 -Based Ceramics

High Strain (0.4%) Bi(Mg2/3Nb1/3)O-3-BaTiO3-BiFeO3 Lead-Free Piezoelectric Ceramics and Multilayers

Large Flexoelectric Response in PMN-PT Ceramics Through Composition Design

Strong Flexural Resonant Magnetoelectric Effect In Terfenol-D/Epoxy-Pb(Zr,Ti)O-3 Bilayer

Pure Low-Frequency Flexural Mode of [011](c) Poled Relaxor-Pbtio(3) Single Crystals Excited by K(32) Mode.