Abstract:From data collected by an online condition monitoring and fault diagnosis system, a higher pad temperature at the upper guide bearing in a pumped storage power generator unit installed in Guangdong province(GPSPS), China, was found. And also a relatively intensive shaft vibration occurred at the lower guide bearing. By calculating the Reynolds equation and viscosity-temperature equation of the lubricant, a curve between the pre-load coefficient and the increment of pad temperature is obtained, which shows that the larger, the pre-load coefficient, the bigger, the increment of pad temperature. For a practical unit in GPSPS, by employing Transfer matrix method and Wilson-theta method to analyze shaft vibration at different pre-load coefficients of the whole bearing or "pad pair" bearings, the results show that the larger the pre-load coefficient is, the smaller the vibration amplitude is, the shorter the time for vibration to become steady is. And an uneven pre-load coefficient of the "pad pair" bearings will cause shaft orbit from a circle to an ellipse whose long axes is at the direction of the "pad pair" with the lowest pre-load coefficient. Finally, reasons of higher pad temperature of the upper guide bearing and larger shaft vibration at the lower guide bearing are due to the inconsistent relation of bearing assembling clearance or pre-load coefficient of the upper and lower guide bearing, and also due to the too small, uneven pre-load coefficient of "pad pair" bearings. After a scheme for adjusting the bearing clearance is given, data measured show that the analysis and simulation methods are correct and the adjustment scheme to the assembling clearance of the upper and lower guide bearings is feasible and can be used to guide the field maintenance conveniently.

Theoretical and experimental research on turbo-generator shaft alignment using strain gauge method

Bearing Load Identification Based on Shaft Alignment Measurements

Testing and analysis of the load distribution among bearings in a 600 MW steam turbine unit

Method to Calculate Turbine Generator Unit Bearing Load Distribution Using Journal Raising Rate

Shafting Alignment Computing Method of New Multibearing Rotor System under Specific Installation Requirement

Identification of Bearing Load by Three Section Strain Gauge Method: Theoretical and Experimental Research

Thermal Adaptive Alignment Mechanism of Heavy-duty Gas Turbine Bearing Support

Influence Of Typical Assembling Condition Of Bearings On Shaft Lateral Vibration In A Hydraulic Generator Unit

Influence of Elevation Adjustment on Shaft Seal Clearance of a Multi-support Turbo-Generator Unit

Shaft mis-alignment induced vibration of a hydraulic turbine generating system considering parametric uncertainties

Experimental Study of Shafting Load Distribution Based on Strain and Transfer Matrix Method

Calculation and analysis of the bearing load sensitivity of a 1000 MW turbo-generator unit

Laser Based Measurement for the Monitoring of Shaft Misalignment

Study on the Methods of Measurement, Optimization and Forecast of Propulsion Shaft Bearing Load of Ships

The Minimum Circumscribed Circle Based Method for Hydro-Turbine Generator Unit Bearing Clearance Adjustment Analysis

A new multi-disk shaft balancing method for rotating machinery using strain gauges

Influence Of Bearing Pre-Load Coefficient On Shaft Vibration And Pad Temperature In A Hydroturbine Generator Unit - A Case Study

Real-Time Monitoring of Wind Turbine Blade Alignment Using Laser Displacement and Strain Measurement

Testing and Modeling of Shaft Vibrations Due to Misalignment

Thermal error prediction and reliability analysis of the main shaft bearing at wind turbines

Numerical calculation and experimental investigation of the dynamic alignment of ship propulsion shafting based on Latin hypercube stochastic finite element