Abstract:CuS nanocrystalline particles are deposited into the acid-treated multi-wall carbon nanotubes (MWCNTs) film on the fluorine-doped tin oxide glass substrate through the successive ionic layer adsorption and reaction combined with spin-coating technology to form MWCNTs/CuS composite counter electrode (CE). The CuS adding amount is changed in different cycles to discuss its effect mechanism on the photoelectric properties of MWCNTs/CuS composite CE based quantum dot sensitized solar cells (QDSCs). The TiO2 photoanodes are prepared by the electrospinning technique with CdS and ZnS as co-sensitizer. QDSCs are assembled with photoanodes, the polysulfide electrolyte and abovementioned CEs. The CEs are characterized by X-ray diffraction, transmission electron microscope and energy dispersed X-ray detector, which verifies CuS nanocrystalline particles are attached to MWCNTs successfully. The photoelectric properties are analyzed by Nyquist, Tafel and J–V curves. The results show that the introduction of CuS nanocrystalline particles can promote reduction rate of polysulfide species and the short circuit current density (Jsc) to improve catalytic activity, leading to a higher power conversion efficiency (PCE). The MWCNTs based CE with deposition CuS in eight cycles exhibits the best photoelectric performance within all CE samples and the electrical conductivity of MWCNTs/8CuS CE is superior to that of Pt CE according to Nyquist and Tafel curve analysis. PCE of QDSCs with MWCNTs/8CuS CE is up to 5.186%, which is a little lower than that of Pt CE (5.250%), but it possesses a higher Jsc value (18.028 mA cm−2) than that of Pt CE (16.057 mA cm−2). The low-cost MWCNTs/CuS composite CE with simple preparation is more suitable than Pt CE for commercial application of QDSCs.

Photoelectrochemical Properties Of Multiwall Carbon Nanotube Assembled With Cdse Quantum Dots

Photoelectrochemical Properties of Multi-Walled Carbon Nanotube Assembled with CdSe Quantum Dots

Capability of Coupled CdSe/TiO2 Heterogeneous Structure for Photocatalytic Degradation and Photoconductivity

Construction of TiO2 NP@TiO2 NT Double-Layered Structural Photoanode to Enhance Photovoltaic Performance of CdSe/CdS Quantum Dots Sensitized Solar Cells

Capability of coupled CdSe/TiO2 heterogeneous structure for photocatalytic degradation and photoconductivity.

Highly-enhanced Performance of TiO 2 Nanotubes Attached with CdS quantum Dots

Controllable Photoelectron Transfer in CdSe Nanocrystal-Carbon Nanotube Hybrid Structures.

Effect of Carbon Nanotubes on the Properties of Polymer Moppv-Pbse Quantum Dot Composites

Quantum dot decorated aligned carbon nanotube bundles for a performance enhanced photoswitch

Enhanced Electron Transfer Rate for Quantum Dot Sensitized Solar Cell Based on CNT-TiO2 Film.

Bulk Heterojunction Photovoltaic Devices Based on A Poly(2-Methoxy, 5-Octoxy)-1, 4-Phenylenevinylene-single Walled Carbon Nanotube-Znse Quantum Dots Active Layer

Efficient Assembly of Multi-Walled Carbon Nanotube-Cdse/zns Quantum Dot Hybrids with High Biocompatibility and Fluorescence Property.

Enhanced Photoresponse of CdS/CMK-3 Composite As a Candidate for Light-Harvesting Assembly

A Nanocomposite of Carbon Quantum Dots and Tio2 Nanotube Arrays: Enhancing Photoelectrochemical and Photocatalytic Properties

“Mulberry-Like” CdSe Nanoclusters Anchored on TiO2 Nanotube Arrays: A Novel Architecture with Remarkable Photoelectrochemical Performance

Photovoltaic Property of Vertically Array Carbon Nanotubes Assembled with CdS QDs

CdS Quantum Dots Sensitized TiO2 Nanotube-Array Photoelectrodes.

Preparation and Photoelectrochemical Properties of CdS Quantum Dot‐sensitized ZnO Nanotube Arrays

Expanding the photoresponse range of TiO2 nanotube arrays by CdS/CdSe/ZnS quantum dots co-modification

Effect of CuS nanocrystalline particles on counter electrodes of multi-wall carbon nanotubes for QDSCs

Photoelectrochemical Conversion from Graphitic C3N4 Quantum Dot Decorated Semiconductor Nanowires