Abstract:Reducing complexity and increasing efficiency of the self-piercing riveting (SPR) process in joining varying sheet stack combinations by reducing the required rivet-die combinations have attracted great attention in the automobile industry. In this paper, the SPR joinability and the joining ranges of material strength and thickness of three types of stack combinations (e.g., steel-aluminium (SA), aluminium-aluminium (AA), and aluminium-steel (AS)) are investigated. In particular, the forming quality improvement process is developed to solve the forming quality defects generated in the riveting process. Two-dimensional axisymmetric finite element (FE) models are developed for each stack combination to simulate the SPR process, and the effects of rivet hardness, die type, sheet material and sheet thickness on the SPR joinability are studied numerically. The results show that the SPR joinability decreases with the increase in the thickness ratio, and the SPR joinability approaches zero when the thickness ratio exceeds 1.47. The rivet H4 and rivet H6 with a flat die can achieve higher SPR joinability compared to rivet H1. Specifically, the rivet H4 is suitable for joining the AA stack, and the rivet H6 is suitable for joining the SA and AS stacks. The average undercut ratio increases with the increase in rivet hardness, while a decreasing tendency is observed with the increase in thickness ratio. The rivet stiffness and hardness can be adjusted to solve the forming quality parameter defects and overcome upsetting deformation defects. Switching the riveting direction for the large thickness ratios (1.47 and 2.08) has proven to be an effective method to achieve successful joining.

Research on Nail-Sheet Joining by Multi-Plate Extrusion Via the Three-Quadrant Method

An Experimental Study on Local Thickening Laws Based on Multi-Plate Extrusion

Steel-aluminum Plastic Clinching of an Inclined Wall Die

Modeling of Fast Pre-Joining Processes Optimization for Skin-Stringer Panels

Experimental study of the static behavior of tubular N-joints

Deformation and Fracture Mechanisms of Automated Fiber Placement Pre-Preg Laminates under Out-of-plane Tensile Loading

Analysis of joint formation mechanisms for self-piercing riveting (SPR) process with varying joining parameters

Numerical Simulation and Experiment of Self-Piercing Riveting with Solid Rivet Joining Multi-Layer Aluminum Sheets

Double-layer sheets SPR-bonded hybrid joining method of an extendable die

Research on the Micro Sheet Stamping Process Using Plasticine as Soft Punch

Analysis and optimization of rivet load distribution in multi-rivet connections of thermoplastic composite rivets

An experimental investigation on press joining mechanism and bearing behavior of single-lap composite riveted joints

Experimental and Numerical Investigations on the Impact of Surface Conditions on Self-Piercing Riveted Joint Quality

Numerical Simulation and Process Improvement of a Typical Car Thread Plate

Experimental investigation of the novel dieless clinching process free of blank holder

Numerical investigation of joinability and forming quality improvement on self-piercing riveting process with varying sheet stack combinations

Investigation of the flat-clinching process for joining three-layer sheets on thin-walled structures

Influence of sheet thickness on mechanical behaviors of the clinched joints produced by single-point butt clinching process

Numerical Simulation and Experimental Research on Multi-Point Forming of Aluminum Alloy Sheets Based on Ultrasonic Vibration

Physical Simulation Method for the Investigation of Weld Seam Formation During the Extrusion of Aluminum Alloys

Research on a single-point butt clinching process with various forming forces