Experimental investigation of dust MEC measurement

jingjie yuan,weixing huang,hua ji,niansheng kuai,yi wu
DOI: https://doi.org/10.1016/j.powtec.2011.10.033
IF: 5.64
2012-01-01
Powder Technology
Abstract:The minimum explosible concentration (MEC) is a crucial parameter in dust explosion evaluation and prevention. The standardized method currently used to determine the MEC relies on the measurement of explosion pressure Pm and the test results are strongly affected by dust dispersion behaviors. To investigate this effect, systematical experiments were performed for coal dust explosion in the Siwek 20-liter sphere. It is found that the measured values of Pm are apparently dependent on the ignition delay time tig because of the time-dependence of dust dispersion behaviors. For the dust with a given mass concentration and size distribution, there always exists an optimal ignition delay time tig,opt at which the Pm will reach its maximum value, Pmax, and a slight deviation of tig from the tig,opt may cause the measured Pm to be obviously lower than the Pmax. To reliably determine the MEC, the tig,opt should be adopted in the test, rather than the fixed tig of 60ms as prescribed by IEC, otherwise, the resultant MEC may be overestimated. Based on the analysis of flame propagation in dust cloud, an alternative method by using combustion duration time tcom is proposed to determine the MEC. Analysis for experimental data shows that the values of MEC determined by using tcom are basically consistent with those obtained by using Pm at the tig,opt, but less affected by the tig, since the sensitivity of the tcom to the tig is much less than that of the Pm.
What problem does this paper attempt to address?