Abstract:The temperature field evolution and material removal process during picosecond (ps) laser micro-grooving of single crystalline germanium (Ge) are explored by developing a 2D two-temperature model (TTM). The transient temperature-dependent thermal and optical properties of electrons and lattice are incorporated for accurate calculations, and the electron-lattice coupling strength is estimated considering the electron transition from valence band (VB) to conduction band (CB) mainly caused by one photon absorption. Different material removal mechanisms, i.e. the thermal way caused by vaporization and the athermal manner resulted from covalent bonds breakage, are proposed and compared with experimental results. The variation trends of the thermal model predicted groove depths are similar and consistent with the measured ones within selected ranges, while the athermal model leads to groove depth far from reality, demonstrating that the vaporization-caused mechanism is the proper one. Employing the verified model, simulation study is conducted to explore the evolution of temperature field under different fluences. Under a low fluence of 0.071 J/cm2, the peak electron temperature shows a decreasing trend with pulse width, and the temperatures of electron and lattice evolve in a similar pattern when the pulse duration is wider than 200 ps. For a higher fluence of 7.074 J/cm2, lattice temperature increases up to melting and boiling point within 1 ps and 3 ps, respectively, and the groove depth produced by a 12 ps pulse heating is about 0.65 μm. Afterwards, residual heat diffusion during pulse interval and further material removal during following pulse heating will occur, leading to a deeper groove. Moreover, the effects of laser power and critical free electron density on the machining process are also analysed, demonstrating that an increase in any of these two parameters results in a faster element removal.

Femtosecond Laser Processing of Germanium: Anab Initiomolecular Dynamics Study

Femtosecond Laser Processing of Germanium: An Ab Initio Molecular Dynamics Study

Numerical Simulations of Germanium Nanofilm under Femtosecond Pulse Laser Heating

Numerical Analysis of Ultrashort Pulse Laser-Induced Thermomechanical Response of Germanium Thin Films

Studies on Infrared Absorption Loss of Antireflection Coatings on Germanium and Potassium Chloride Substrates at the Wavelength of 10.6μm by Photothermal Deflection Technique

Optical and microstructural studies of femtosecond laser treated amorphous germanium thin coatings

A numerical study of picosecond laser micro-grooving of single crystalline germanium: Mechanism discussion and process simulation

Energy-dependent Femtosecond LIPSS on Germanium and Application in Explosives Sensing

Subarachnoid hemorrhage associated with von Willebrand's disease--case report.

Combined Continuum-Atomistic Modeling of Ultrashort-Pulsed Laser Irradiation of Silicon

Non-thermal lattice dynamics in α-quartz induced by femtosecond laser pulses: An ab initio study

Laser Cooling of Germanium Semiconductor Nanocrystals

Realization of Optical Modulation in Germanium Oxide Glass by Femtosecond Laser Direct Writing

Measurement and modeling of strain waves in germanium induced by ultrafast laser pulses

Dry Etching of Germanium with Laser Induced Reactive Micro Plasma

Femtosecond Laser Deposition of Germanium Selenide onto Silicon Platform at Different Substrate Temperatures

Numerical Investigation of the Kinetics of Non-Equilibrium Phase Transitions in Silicon Induced by an Ultra-Short Laser Pulse

Pausing ultrafast melting by timed multiple femtosecond-laser pulses

Germanium Sub-Microspheres Synthesized by Picosecond Pulsed Laser Melting in Liquids: Educt Size Effects

Design of an on-chip germanium cavity for room-temperature infrared lasing