Abstract:Gas foil bearings have bright application prospects in oil-free turbomachinery such as aircraft air cycle machines, compressors and gas turbines. To extend the applicability of foil bearings to high-speed and heavy-load systems, the axial force produced primarily by the pressure difference between the turbine and compressor sides must be taken into consideration. The thrust disc of the rotor is typically used to sustain the axial force and maintain the attitude of the rotor in a rotor-bearing system. In an analytical model used to predict the performance of gas foil thrust bearings (GFTBs), fluid–structure interaction must be considered because of the coupling effects of hydrodynamic lubrication and the compliance of bearing surface. In this study, a link-spring structural model was employed to calculate the equivalent vertical stiffness of the bump foil. This model exhaustively considered the effect of three factors: flexibility of the bump foil, interactions between bumps, and frictional forces at the contact surfaces. In addition, top foil deflection that directly affects film thickness is calculated using a finite-element shell model. The static and dynamic characteristics of GFTBs were predicted after solving the steady-state Reynolds equation and two linearized dynamic coefficient equations which were obtained with perturbation method by using finite-difference method. The structural deformation equation was substituted into the Reynolds equations in the calculation process. The calculated static load was compared with the published experimental data, and the results validated the theoretical analysis. Thereafter, the static and dynamic characteristics including impact of rotational speed, initial minimum film thickness and the ratio of the inlet to outlet film thicknesses were analyzed. Parametric studies were also conducted to evaluate the effect of different structural parameters of the bump foil and journal tilting on the static characteristics of GFTBs. Because the proposed analytical model is completely algebraic, it can be easily programmed for accurately and effectively investigating the performance of GFTBs.

Experimental Investigation on the Multi-Decked Protuberant Gas Foil Journal Bearing

Effects of bearing clearance and supporting stiffness on performances of rotor-bearing system with multi-decked protuberant gas foil journal bearing

Numerical and Experimental Studies on Stability of Cryogenic Turbo-Expander with Protuberant Foil Gas Bearings

Comparative studies on double-layered protuberant foil bearing and Hydresil foil bearing

Performance Analysis of the Cylinder Gas Film Seal between Dual-Rotor Reverse Shafts Considering Lubrication and Centrifugal Expansion Effects

Experimental Study on Multi-Decked Protuberant Foil Thrust Bearing with Different Number of Thrust Pads

Study on Dynamic Pressure Effect of Gas Bearings in Fuel Cell Vehicles

Numerical investigation on the rotordynamics of a high-speed air compressor supported by gas foil bearings

Rotor dynamic experimental investigation of an ultra-high-speed permanent magnet synchronous motor supported on a three-pad bidirectional gas foil bearing

Stability and Vibration Characteristics of A Rotor-Gas Foil Bearings System with High-Static-Low-Dynamic-Stiffness Supports

Theoretical and experimental research on static stiffness, performance, and lift-off characteristics of multi-layer gas foil thrust bearings

Elastro-hydrodynamic Lubrication Model of Multi-Decked Foil Thrust Bearing with Copper Wire Support

Numerical and experimental investigation on dynamic performance of bump foil journal bearing based on journal orbit

Numerical Investigation of Bump Foil Configurations Effect on Gas Foil Thrust Bearing Performance Based on a Thermos-Elastic-Hydrodynamic Model

Study of load carrying mechanism of a novel three-pad gas foil bearing with multiple sliding beams

Numerical and experimental investigation on the performance of hybrid porous gas journal bearings

Theoretical and experimental investigations on load-carrying capacity of separated gas foil thrust bearing

Parametric study on static and dynamic characteristics of bump-type gas foil thrust bearing for oil-free turbomachinery

Effect of herringbone groove structure parameters on the static performance of gas foil herringbone groove thrust bearings

DYNAMIC RESEARCH AND DESIGN OF THREE-DIMENSIONAL ALL GAS FOIL BEARING ROTOR SYSTEM

Simulation and Experimental Verification of Dynamic Characteristics on Gas Foil Thrust Bearings Based on Multi-Physics Three-Dimensional Computer Aided Engineering Methods