Abstract:Metal mesh foil bearings (MMFBs), simple to construct and inexpensive, are a promising bearing technology for oil-free microturbomachinery operating at high speed and high temperature. Prior research demonstrated the near friction-free operation of a MMFB operating to 60 krpm and showing substantial mechanical energy dissipation characteristics. This paper details further experimental work and reports MMFB rotordynamic force coefficients. The test rig comprises a turbocharger driven shaft and overhung journal onto which a MMFB is installed. A soft elastic support structure akin to a squirrel cage holds the bearing, aiding to its accurate positioning relative to the journal. Two orthogonally positioned shakers excite the test element via stingers. The test bearing comprises a cartridge holding a Copper wire mesh ring, 2.7 mm thick, and a top arcuate foil. The bearing length and inner diameter are 38 mm and 36.5 mm, respectively. Experiments were conducted with no rotation and with journal spinning at 40–50 krpm, with static loads of 22 N and 36 N acting on the bearing. Dynamic load tests spanning frequencies from 150 to 450 Hz were conducted while keeping the amplitude of bearing displacements at 20 μm, 25 μm, and 30 μm. With no journal spinning, the force coefficients represent the bearing elastic structure alone because the journal and bearing are in contact. The direct stiffnesses gradually increase with frequency while the direct damping coefficients drop quickly at low frequencies (< 200 Hz) and level off above this frequency. The damping combines both viscous and material types from the gas film and mesh structure. Journal rotation induces airborne operation with a hydrodynamic gas film separating the rotor from its bearing. Hence, cross-coupled stiffness coefficients appear although with magnitudes lower than those of the direct stiffnesses. The direct stiffnesses, 0.4 to 0.6 MN/m within 200–400 Hz, are slightly lower in magnitude as those obtained without journal rotation, suggesting the air film stiffness is quite high. Bearing direct stiffnesses are inversely proportional to the bearing motion amplitudes, whereas the direct equivalent viscous damping coefficients do not show any noticeable variation. All measurements evidence a test bearing system with material loss factor (γ) ∼ 1.0, indicating significant mechanical energy dissipation ability.

Effects of bearing clearance and supporting stiffness on performances of rotor-bearing system with multi-decked protuberant gas foil journal bearing

Numerical and Experimental Studies on Stability of Cryogenic Turbo-Expander with Protuberant Foil Gas Bearings

Experimental Study on Multi-Decked Protuberant Foil Thrust Bearing with Different Number of Thrust Pads

Comparative studies on double-layered protuberant foil bearing and Hydresil foil bearing

Study on Dynamic Pressure Effect of Gas Bearings in Fuel Cell Vehicles

Numerical investigation on the rotordynamics of a high-speed air compressor supported by gas foil bearings

Stability and Vibration Characteristics of A Rotor-Gas Foil Bearings System with High-Static-Low-Dynamic-Stiffness Supports

Numerical Investigation of Bump Foil Configurations Effect on Gas Foil Thrust Bearing Performance Based on a Thermos-Elastic-Hydrodynamic Model

Theoretical and experimental research on static stiffness, performance, and lift-off characteristics of multi-layer gas foil thrust bearings

Parametric study on static and dynamic characteristics of bump-type gas foil thrust bearing for oil-free turbomachinery

Rotor dynamic experimental investigation of an ultra-high-speed permanent magnet synchronous motor supported on a three-pad bidirectional gas foil bearing

Theoretical and experimental investigations on load-carrying capacity of separated gas foil thrust bearing

Study of load carrying mechanism of a novel three-pad gas foil bearing with multiple sliding beams

Numerical and experimental investigation on dynamic performance of bump foil journal bearing based on journal orbit

Effect of herringbone groove structure parameters on the static performance of gas foil herringbone groove thrust bearings

The fluid-thermal-structural interaction analysis of a new multifoil aerodynamic thrust bearings

Numerical and experimental investigation on the performance of hybrid porous gas journal bearings

Investigations on the nonlinear dynamic characteristics of a rotor supported by hybrid foil magnetic bearings

Effects of Structure Parameters on Static Performance of Gas Foil Bearings Based on a New Fully Coupled Elastic–Aerodynamic Model

Numerical and experimental studies on the thermal and static characteristics of multi-leaf foil thrust bearing

Metal Mesh Foil Bearing: Effect of Motion Amplitude, Rotor Speed, Static Load, and Excitation Frequency on Force Coefficients