Abstract:The electrical explosion of a conductor driven by a pulsed current can be used to simulate the effects of explosions in the laboratory, including the resulting shock waves and bubble dynamics. A fine metallic wire can also be used to initiate pulsed discharge in different media. This study shows images of an exploding wire across an air–water interface for the first time in the literature. The transient process was analyzed using high-speed backlit photography as well as waveforms of the spectrum and discharge. Streamer-like discharge developed from a triple-junction point within the current pause to induce a restrike in metallic aerosol, verifying that gas discharge was prevalent in the system. An upward dense plasma jet accompanied by a crown-like water spike was then observed and led to violent plasma–water interactions (mushroom cloud-like cluster) that were examined through a hydrodynamic simulation. The Stark broadening of the Hα line at 656.28 nm suggested that the electron density of the reaction zone could be 1018 cm−3 or higher. The resolved spatial–temporal images revealed that the plasma evolution process (in μs) was much faster than hydrodynamic processes, including damage to the interface and perturbations of the bubbles (in ms). Water, thus, remained in a “rigid” state during the pulsed discharge, and the explosion of the wire in it was not an adiabatic process at a timescale of 102 μs. Recombination and heat loss through the electrode governed the evolution of the post-discharge plasma, and the microscopic images revealed nano-lamellate nucleation on the surface of the electrode.

Generation of Electrohydraulic Shock Waves by Plasma-Ignited Energetic Materials: I. Fundamental Mechanisms and Processes

Generation of Electrohydraulic Shock Waves by Plasma-Ignited Energetic Materials: Ii. Influence of Wire Configuration and Stored Energy

Ignition Performance of Cu-wire Electrical Explosion Plasma on Energetic Materials

Shock Wave Characteristics Generated by Electrical Explosion of Different Wires in Water

Generation of Electrohydraulic Shock Waves by Plasma-Ignited Energetic Materials: Iii. Shock Wave Characteristics with Three Discharge Loads

Experimental and Numerical Study of Shock Wave Propogation Produced by Underwater Electrical Wire Explosion

Underwater Shock Wave Generated by Exploding Wire Ignited Energetic Materials and Its Applications in Reservoir Stimulation

Parameter Regulation of Underwater Shock Waves Based on Exploding-Wire-ignited Energetic Materials

PRELIMINARY EXPERIMENT ON SHOCK WAVES GENERATED BY UNDERWATER ELECTRICAL EXPLOSION OF WIRES

Experiments on the characteristics of underwater electrical wire explosions for reservoir stimulation

Experimental Study on Shock Wave Characteristics of Ammonium Nitrate Ignited by Wire Explosion

Study of the Shock Waves Characteristics Generated by Underwater Electrical Wire Explosion

Electrical Explosion Across Gas–liquid Interface: Aerosol Breakdown, Shock Waves, and Cavity Dynamics

Enhancement of Shock Wave from Underwater Electrical Wire-Array Explosion at a Fixed Energy by Changing Wire Connection

Shock wave generated by composite energetic material driven by electrical non-penetrating wire explosion plasma

Numerical Investigation of Shock Wave Characteristics at Microsecond Underwater Electrical Explosion of Cu Wires

Electrical wire explosion as a source of underwater shock waves

Research on the sub-millisecond underwater electrical wire explosion process

Detonation of a nitromethane-based energetic mixture driven by electrical wire explosion

Relationship Between Energy Deposition and Shock Wave Phenomenon in an Underwater Electrical Wire Explosion