Abstract:Lignite is considered as an raw energy material with abundant supply worldwide. However, power plants that directly fire lignite exhibit low efficiency, which can be improved by applying lignite pre-drying technologies. Lignite-Fired power plants integrated with a steam or flue gas dryer (SPLPS or FPLPS) are designed and optimized. Previous studies mainly focused on the thermodynamic performance and techno-economic analyses of single drying technology. However, sensitivity analyses of parameters are disregarded in the techno-economic analysis. Therefore, system configurations are optimized in this study, and different drying technologies are subsequently compared on the basis of their techno-economic performance. Moreover, the sensitivity analyses of key parameters are investigated. Optimization results show that the steam extraction pressure of SPLPS should not be substantially low, and optimum extraction should be performed at steam turbine 4# regenerative extraction (0.9539 MPa, 360.9 degrees C) or 5# (0.3758 MPa, 249.6 degrees C). This approach differs from the thermodynamic performance presented in previous studies. Moreover, the detailed optimization strategy of SPLPS is realized on the basis of net present value (NPV) and payback period. The comparison results show that the maximum NPV of FPLPS would be 9.5 million USD more than the earnings from a conventional lignite-fired power system (CLPS), whereas that of SPLPS would be 40.1 million USD more than the earnings from CLPS. However, the economic benefits of FPLPS and SPLPS can be reversed with the fluctuation of parameters based on sensitivity analyses.

Energy and Water Conservation at Lignite-Fired Power Plants Using Drying and Water Recovery Technologies

Water Extraction from High Moisture Lignite by Means of Efficient Integration of Waste Heat and Water Recovery Technologies with Flue Gas Pre-Drying System

Energy Analysis of a Lignite Predrying Power Generation System with an Efficient Waste Heat Recovery System

Thermodynamic Analysis of an Improved Flue Gas Pre-Dried Lignite-Fired Power System Integrated with Water Recovery and Drying Exhaust Gas Recirculation

Lignite Drying and Its Utilization for Waste Heat Recovery from Flue Gases in Power Plants

System Design and Theoretical Analysis of Lignite-fired CHP Based on Lignite Pre-drying and Waste Heat Recovery from Dryer Exhaust

Energy saving potential analysis on boiler flue gas pre-dried lignite-fired power system:the effect of lignite kinds and unit cooling types

Theoretical Study of Lignite-Fired Power System Integrated With Heat Pump Drying

Energy And Exergy Analyses Of A Lignite-Fired Power Plant Integrated With A Steam Dryer At Rated And Partial Loads

Simulation Study on Lignite-Fired Power System Integrated with Flue Gas Drying and Waste Heat Recovery – Performances under Variable Power Loads Coupled with Off-Design Parameters

Pilot Study on In-depth Water Saving and Heat Recovery from Tail Flue Gas in Lignite-fired Power Plant

A Combined-Type Fluid-Bed Dryer Suitable for Integration Within a Lignite-Fired Power Plant: System Design and Thermodynamic Analysis

A Novel Lignite-Fired Power Plant Integrated with A Vacuum Dryer: System Design and Thermodynamic Analysis

Integration Of Evaporative Dryers Into Lignite-Fired Power Plants: A Review

Techno-economic Analysis of the Lignite-Fired Power Plant Integrated with a Steam or Flue Gas Dryer

The Comprehensive Economic Analysis of Lignite Dewatering

A green and efficient lignite-fired power generation process based on superheated-steam-dried open pulverizing system

Comparison on Lignite Drying and Quality Improvement Technology, as Well as Moisture and Heat Recovery and Utilization Plan

A novel lignite pre-drying system integrated with flue gas waste heat recovery at lignite-fired power plants

Thermodynamic analysis of pre-drying methods for pre-dried lignite-fired power plant

Thermodynamic Analysis on A Lignite-Fired Power System Integrated with A Steam Dryer: Investigation on Energy Supply System of the Dryer