Abstract:The utilization of photovoltaic/thermal-thermoelectric generator (PV/T-TEG) systems holds great promise for achieving efficient utilization of the full solar spectrum. However, the conventional tandem structure design fails to effectively address the issue of temperature mismatch between the PV and TEG components during operation, highlighting the need for an innovative solution. To address this limitation, an innovative bifacial PV/T-TEG system was developed in this study. A practical test setup was employed to compare the performance of the conventional tandem system with the novel bifacial system under controlled laboratory conditions. The influences of solar radiation and water flow rate on the temperature, electrical, and thermal characteristics of both system configurations were thoroughly investigated and analyzed. The experimental findings unequivocally demonstrate that the recommended bifacial system exhibits lower average PV module temperature and a larger temperature difference in the TEG component when compared to the conventional tandem configuration. Specifically, the temperature reduction in the PV component could be higher than 18 K, while the improvement in temperature difference in the TEG component was larger than 5 K. Moreover, both the PV and TEG components show significantly enhanced power output. The PV power output experiences an improvement ranging from 4.7% to 12.7%, while the maximum power enhancement ratio for TEG reaches 27.8%. Additionally, a notable enhancement of 17% in thermal efficiency is observed when comparing the two systems. The thermal efficiency of the bifacial system improves by 8.37%, and for the tandem system, the improvement is 10.73%, achieved by adjusting the water flow rates.

Comparative simulation analyses on dynamic performances of photovoltaic–thermal solar collectors with different configurations

Dynamic performances modeling of a photovoltaic-thermal collector with water heating in buildings

Comparative analyses on dynamic performances of photovoltaic–thermal solar collectors integrated with phase change materials

Dynamic characteristics modeling of a hybrid photovoltaic–thermal solar collector with active cooling in buildings

Dynamic Performance Analysis of Photovoltaic–thermal Solar Collector with Dual Channels for Different Fluids

Performance study and parametric analysis of a novel heat pipe PV/T system

Computational Simulation and Analysis of Major Control Parameters of Time-Dependent PV/T Collectors

Numerical Simulation and Experimental Validation of Tri-Functional Photovoltaic/Thermal Solar Collector

Performance Evaluations and Applications of Photovoltaic–thermal Collectors and Systems

Experimental Analysis of a Novel Solar PV/T Collector

Dynamic Performance of PV/T Solar-assisted Heat Pump System

Performance and application boundary analysis of solar PV/T heat pump system

Comparative Study on Performances of A Heat-Pipe Pv/T System and A Heat-Pipe Solar Water Heating System

Performance Assessment and Improvement of Photovoltaic-Thermal System based on Energy, Exergy, Economic and Environment Analysis

NUMERICAL STUDY ON THE ELECTRIC AND THERMAL PERFORMANCE OF HYBRID PV/T COLLECTOR WALL

Comparative Study on Two Photovoltaic and Thermal Solar Moduleds with Point-Focus Fresnel Concentrator

Experimental study on performance assessment of photovoltaic/thermal-thermoelectric generator systems: Bifacial and tandem types

Research and numerical analysis on performance optimization of photovoltaic-thermoelectric system incorporated with phase change materials

Computer modeling and experimental validation of a building-integrated photovoltaic and water heating system

Performance Analysis of a Photovoltaic Heat Pump

Numerical and Parametric Analysis for Enhancing Performances of Water Photovoltaic/Thermal System