Abstract:Liquid viscosities for two binary systems of chlorodifluoromethane (R22) + Trans-1,3,3,3-Tetrafluoropr op-1-ene (R1234ze(E)) and chlorodifluoromethane (R22) + 2,3,3,3-tetrafluoroprop-1-ene (R1234yf) were measured with a vibrating-wire viscometer. Measurements were operated at 5 isotherms over the tem-perature range from (273 to 353) K and at pressures from slightly above saturation pressure up to 15 MPa. Four mole fractions of R22 were covered for each system, more specifically, x(1) = (0.2269, 0.4376, 0.6379, and 0.8212) for R22 (1) + R1234ze(E) (2) and x(1) = (0.2214, 0.4510, 0.6296, and 0.8163) for R22 (1) + R1234yf (2). The combined expanded uncertainty (k = 2) of the measured viscosity is about 2.0%. In addition, the extended hard-sphere (EHS) model was used to correlate the experimental viscosi-ties for each individual composition, respectively. The average absolute relative deviations between the calculation and experiment for R22 + R1234ze(E) and R22 + R1234yf are within 0.3% and 0.4%, respectively. In addition, the EHS model combined with the mixing rules was applied to estimate the viscosity of these binary mixtures. The predicted results are in good agreement with the experimental data with relative deviations range from (-4.41 to 3.15) %. (C) 2021 Elsevier Ltd.

Liquid Viscosity and Surface Tension of R1234yf and R1234ze under Saturation Conditions by Surface Light Scattering

Surface Tension and Liquid Viscosity Measurement for Binary Mixtures of R134a with R1234yf and R1234ze(E)

Measurements of Surface Tension of R1234yf and R1234ze(E)

Surface Tension and Liquid Viscosity of R32+R1234yf and R32+R1234ze

Thermal Diffusivity Measurements of R1234yf and R1234ze(E) under Saturation Conditions Using Dynamic Light Scattering Method

Measurements of the isobaric heat capacity of R1234yf in liquid phase at temperatures from 305 K to 355 K and pressures up to 5 MPa

Measurements of the Isobaric Heat Capacity of Pressurized Liquid Trans-1,3,3,3-tetrafluoropropene [r1234ze(e)] by Scanning Calorimetry

Experimental Investigation of Vapor–Liquid Equilibrium for 2,3,3,3-Tetrafluoropropene (Hfo-1234Yf) + Trans-1,3,3,3-tetrafluoropropene (Hfo-1234Ze(e)) at Temperatures from 284 to 334 K

Vapor–Liquid Equilibrium for the Binary Systems 1,1,2,3,3,3-Hexafluoro-1-propene (R1216) + 2,3,3,3-Tetrafluoroprop-1-ene (r1234yf) and 1,1,2,3,3,3-Hexafluoro-1-propene (R1216) + Trans-1,3,3,3-tetrafluoropropene (R1234ze(e))

Isothermal Vapor–Liquid Equilibria of the Absorption Working Pairs (r1234yf + NMP, R1234yf + DMETrEG) at Temperatures from 293.15 K to 353.15 K

Viscosity Measurements for 2,3,3,3-Tetrafluoroprop-1-ene (r1234yf) and Trans-1,3,3,3-tetrafluoropropene (R1234ze(e))

Saturated Liquid Dynamic Viscosity and Surface Tension of Trans-1-chloro-3,3,3-trifluoropropene and Dodecafluoro-2-methylpentan-3-one

Liquid Viscosity for Binary Mixtures of R22 + R1234ze(E) and R22 + R1234yf from (273 to 353) K at Pressures Up to 15 MPa

Surface Tension and Liquid Viscosity Measurement of Ethyl Fluoride (R161) under Saturation Condition

Liquid Viscosity Measurements for the Binary and Ternary Refrigerant Mixtures of R134a, R1234ze(E), and R1234yf

Experimental Investigation on the Surface Tension of R1234ze(E)/POE Lubricant Mixtures from 278 K to 338 K

Experimental Investigation on the Surface Tension of R1243zf with POE Lubricants from 283 K to 343 K

Measurement and Correlation of the Liquid Viscosity of Trans-1-chloro-3,3,3-trifluoropropene (R1233zd(e))

Experiments on Liquid Viscosity and Surface Tension of Binary Mixture R161 and R134a

SURFACE TENSION OF 3,3,3-TRIFLUOROPROPENE/LUBRICANT MIXTURES FROM 283 K TO 343K

Measurement and Correlation for the Viscosity of R1234yf/POE85 and R1234ze(E)/POE85 Solutions