Abstract:Amorphous hydrous ruthenium oxide/active carbon (RuO2. xH(2)O/C) powders were prepared by a simple procedure based on the sol-gel process. The precursor was obtained by mixing an aqueous solution of RuCl3 and active carbon powders at pH 7. When annealing the precursor at 150 degreesC for 7-9.5 h, the RuO2. xH(2)O/C powders obtained had the highest specific capacitance. Transmission electron microscopy photographs showed that the RuO2. xH(2)O primary particles were about 10-15 nm diam. They adhered to form large porous secondary particles. A modeling capacitor was made with electrodes comprised of RuO2. xH(2)O/C powder and 30% H2SO4 electrolyte. At 10-20 wt % ruthenium in the electrodes, the specific capacitance remained almost unchanged at 243 F/g, which included both the electric double-layer capacitance associated with the high surface area of active carbon and redox capacitance associated with ruthenium oxide. About 52% of the RuO2 in the RuO2. xH(2)O/C powders was utilized. More than 50% of the capacitance in the electrode with 12.1% ruthenium was due to the formation of the double layer, but for the electrode with 21.1% ruthenium, the capacitance attributed to the double layer dropped to 16.8% of the total capacitance. When the electrodes contained ruthenium from 35 wt % to pure RuO2. xH(2)O, the specific capacitance increased from 350 to 715 F/g. The specific capacitance was proportional to the mass of the ruthenium in the electrodes. This enabled the specific capacitance to be controlled by changing the mass ratio of RuCl3 to active carbon in the preparation. Physical properties of the material and electrochemical characteristics of electrodes are also reported along with the capacitor performance. (C) 2001 The Electrochemical Society.

Preparation and Electrochemical Performance of PPy/GO-RuO$lt;inf$gt;2$lt;/inf$gt; Film Electrode for Micro-supercapacitor

Design and fabrication of a RuO2 microelectrode-based micro-supercapacitor

Oxidative MnO2 Template Assisted Electrochemical Fabrication of Graphene/Polypyrrole Supercapacitor Electrodes

Ultra-Fine Ruthenium Oxide Quantum Dots/Reduced Graphene Oxide Composite as Electrodes for High-Performance Supercapacitors

Pulsed electrochemical fabrication of graphene/polypyrrole composite gel films for high performance and flexible supercapacitors

Preparation of Graphene/Polypyrrole Composite Film Via Electrodeposition for Supercapacitors

Electrochemical Performance of RuO2/Active Carbon Composite Electrodes

Facile Preparation of Polypyrrole/graphene Oxide Nanocomposites with Large Areal Capacitance Using Electrochemical Codeposition for Supercapacitors

Investigations on Polypyrrole/Prussian Blue/Ruthenium Dioxide Based Ternary Nanocomposite as an Electrode Material for Supercapacitors

Preparation and Characterization of Micro Polypyrrole Electrodes for Supercapacitor

Preparation of a novel porous gel electrolyte and its application in micro supercapacitor

One-step Fabrication of Heterogeneous Conducting Polymers-Coated Graphene Oxide/carbon Nanotubes Composite Films for High-Performance Supercapacitors

Hydrous–ruthenium–oxide thin film electrodes prepared by cathodic electrodeposition for supercapacitors

Iron (II and III) Oxides/Reduced Graphene Oxide/Polypyrrole Ternary Nanocomposite As Electrochemical Supercapacitor Electrode

Flexible Electrodes Based on Polypyrrole/manganese Dioxide/polypropylene Fibrous Membrane Composite for Supercapacitor

Facile Hydrothermal Synthesis of Mesoporous Nickel Oxide/reduced Graphene Oxide Composites for High Performance Electrochemical Supercapacitor

Preparation And Electrochemistry Of Hydrous Ruthenium Oxide/Active Carbon Electrode Materials For Supercapacitor

Preparation of a high-capacity three-dimensional CuS/Cu 2 S/rGO composite thin film electrode and its application in supercapacitors

Synthesis of a rGO/NiO composite with a hierarchical porous structure by self-assemblyand its electrochemical performance as a supercapacitor electrode

Fabrication of composite material of Gd2O3, Co3O4 and graphene on nickel foam for high-stability supercapacitor

Mesoporous Composite Nickel Cobalt Oxide/graphene Oxide Synthesized Via a Template-Assistant Co-Precipitation Route As Electrode Material for Supercapacitors