Abstract:As tellurides and selenides of Bismuth are extensively used thermoelectric materials in the low-temperature range with refrigeration application, A concerted effort is put forth to boost the ZT by co-doping the pristine Bi 2 Se 3 with antimony (Sb) on cation end and tellurium (Te) on anion side of the compound. The double sintered solid-state reaction method is employed in the preparation of Bi 2 Se 3 and (Bi 1− x Sb x ) 2 Se 2.7 Te 0.3 polycrystalline pellets, with x = 0.02, 0.04, and 0.06. The sample exhibits a rhombohedral structure with the space group of R m. FESEM and EDAX analysis are used to confirm surface morphology and elemental composition of the produced samples. The thermoelectric measurements for the pristine and co-doped samples were conducted by the physical property measurement system as well as a considerable increase in the Seebeck coefficient of − 115 μV/K is observed for 0.02 doping of the Sb which is 4.2 times greater than as for pristine (S = − 28 μV/K). Higher concentration doping ( x = 0.04, 0.06) has not reflected any Seebeck coefficient advancement. In contrast, the lowest total thermal conductivity at a low-temperature regime (< 50 K) is observed for x = 0.06 doping concentration which at near room temperature increases beyond the pristine thermal conductivity; whereas, x = 0.02, 0.04 doping concentration shows a decrement in total thermal conductivity at low, at room temperature region the values are almost equivalent to that of pristine. The co-doped samples' electrical resistivity is substantially less than pristine sample. The highest power factor of 3 × 10 –4 μW/mK 2 is obtained for the x = 0.02 sample. The highest ZT value for the x = 0.02 sample is almost 28 times more than a pristine sample. We conducted a study where we combined experimental and DFT methods to investigate thermoelectric properties incorporated into pristine and doped with antimony and tellurium on Bi 2 Se 3 . We have employed this combination to investigate the partial density of states, Seebeck coefficient, power factor using the Boltzmann transport equation. Theoretical thermoelectric data were derived and compared to experimental observations. Hence, using combined experimental and theoretical investigations helps to predict with higher accuracy of thermoelectric properties of semiconducting materials.

A Theoretical Investigation on Thermoelectric Performance of Ternary (bi 1− X Sb X ) 2 Te 3 Compound

Enhanced Thermoelectric Performance of (Sb0.75bi0.25)(2)te-3 Compound from First-Principles Calculations

Thermoelectric performance of binary lithium-based compounds: Li 3 Sb and Li 3 Bi

Thermoelectric Performance of Binary Lithium-Based Compounds: Li3Sb and Li3Bi

Nanostructuring and improved performance of ternary Bi–Sb–Te thermoelectric materials

High-temperature thermoelectric properties with Th$_{3-x}$Te$_4$

Liquidus Projection of the Ternary Bi-Sb-Te Thermoelectric Material System

Highly Enhanced Thermoelectric and Mechanical Properties of Bi-Sb-Te Compounds by Carrier Modulation and Microstructure Adjustment

Thermoelectric Properties of Quaternary Ag-Bi-Sb-Te Alloys

Effect of Composition Adjustment on the Thermoelectric Properties of Mg3Bi2-Based Thermoelectric Materials

Unraveling electronic origins for boosting thermoelectric performance of p-type (Bi,Sb) 2 Te 3

Microstructure and Thermoelectric Properties of Cubic AgPb18Sb1−xTe20 (x = 0.1, 0.3, 0.5) Compounds

Thermoelectric performance of (AgBiTe2)1-x(SnTe)x with stable cubic enabled by enhanced configurational entropy

Quantum Chemistry Calculation And Transport Of Bi2te3 And Sb2te3

A comprehensive experimental and DFT analysis on thermoelectric properties of Sb, Te co-doped Bi2Se3 polycrystals

Thermoelectric performance of ternary Cu-based chalcogenide Cu2TiTe3

Roles of Cu in the Enhanced Thermoelectric Properties in Bi0.5Sb1.5Te3

Thermoelectric performance of p-type (Bi,Sb)2Te3 incorporating amorphous Sb2S3 nanospheres

Study on the Thermoelectric Characteristics of the Ternary Alkali Metal Compound XMgSb (X = K, Rb, Cs)

Stoichiometric Effect of Sb 2 Te 3 Thin Film on Thermoelectric Property

High performance of Mg3Bi1.5Sb0.5 based materials for power generation: Revealing the counter-intuitive effect of tuning Bi content on the thermoelectric properties