Abstract:The adsorption energetics and growth of lithium vapor on MgO(100) at 300 K was studied using microcalorimetry, in combination with low-energy electron diffraction (LEED), low-energy ion scattering (ISS), Auger electron spectroscopy (AES), and work-function measurements. The MgO(100) samples were films of similar to 4 nm thickness grown on a Mo(100) single crystal. The initial sticking probability of lithium was similar to 0.97, reaching unity by 0.5 monolayer (ML). The AES and ISS signals vary with Li coverage up to 3 ML as expected if the Li atoms stay within the layer where they initially hit (i.e., with no interlayer transport). Initially, lithium adsorbs strongly at the intrinsic surface defects and as two-dimensional (2D) lithium clusters, with a heat of adsorption of 260 kJ/mol. The heat approaches the heat of sublimation of bulk Li (159 kJ/mol) by 0.4 ML, due to the growth of 2D and then three-dimensional (3D) Li islands. Argon-ion sputtering of the surface increases the defect density and the probability for adsorbing Li to find a defect, and thus the heat of adsorption at low coverages. When defects only are being populated, Li exhibits a heat of adsorption of 410 kJ/mol. Comparing heats with recent density functional theory (DFT) calculations suggests that the defect sites are under-coordinated O atoms at steps or kinks, or related structures at dislocations. The work function decreases by similar to 1.8 eV within the first 0.5 ML and then increases to near the value of bulk Li(solid), similar to 2.6 eV, by 3 ML. These results support recent DFT calculations predicting stronger electron transfer from Li to the MgO when at steps and kinks than at terraces, and decreasing charge transfer as 2D Li clusters grow. The work function starts to increase when the growth mode becomes dominated by growth of 3D Li(solid). In spite of a large amount of electron transfer from Li to MgO, Li adatoms have attractive interactions that lead to 2D clustering. For 1-nm-thick MgO films, the heat of adsorption was higher by 60-20 kJ/mol than for 4 nm films in the entire range from 0 to 0.7 ML, where adsorption in the first layer dominates.

Formation Processes of an Ordered Mixed Structure: Cu(001)-(2×)R45°-Li,Mg

Density functional theory study on the atomic structure and electronic states of Cu(l00) (√2 × 2 √2)R45°-O surface

Structure Investigation of the Fe on Cu(110) Surface

Density Functional Theory Study on the Atomic Structure and Electronic States of Cu(100) (2×22)R45°-O Surface

The Adsorption with Chiral Structure of Fluorene-1-carboxylic Acid Molecules on Cu(1 1 0) Surface

An Investigation Of The Ordered Au/Cu(111) Surface - Leed, Araes And Arups Results

Structure of Reconstructed Cu(100) Surface Induced by Dissociative Adsorption of Gaseous Oxygen

INTERACTION BETWEEN Li ATOMS ON Si(100)2×1 AND PHASE CHANGE OF SURFACE STRUCTURE

The Atomic Structure and Electronic States of Oxygen- Adsorbed on Cu(110)c(2×1) Surface

Pits and Adatoms at the Interface of 1-Ml C-84/Ag (111)

First principles study of adsorbed Cu_n (n=1-4) microclusters on MgO(100): structural and electronic properties

Formation of positionally ordered but orientationally disordered molecular organization on surface

Lithium Adsorption on MgO(100) and Its Defects: Charge Transfer, Structure, and Energetics

First-principles calculations to investigate Li segregation to Al2CuMg (001)/Al (021) interface in Al–Cu–Li–Mg alloys

Temperature-Dependent Anomalies in the Structure of the (001) Surface of LiCu2O2

Formation of an Ordered Structure by Ion Beam Manipulation and Associated Structural Evolution in the Nanosized Pd–Ru Multilayers

Long-period Stacking Ordered Structures in Mg–3Cu–1Mn–2Zn–1Y Damping Alloy

Plane-wave density functional theory study on the structural and energetic properties of cation-disordered Mg-Al layered double hydroxides.

Theoretical Investigations into Self-Organized Ordered Metallic Semi-Clusters Arrays on Metallic Substrate

Coupled spin-1/2 antiferromagnetic chain Cs$_2$LiRuCl$_6$ with partially disordered crystal lattice

Probing surface structure on two-dimensional metal-organic layers to understand suppressed interlayer packing