Abstract:Plasticity in body-centred cubic (BCC) metals, including dislocation interactions at grain boundaries, is much less understood than in face-centred cubic (FCC) metals. At low temperatures additional resistance to dislocation motion due to the Peierls barrier becomes important, which increases the complexity of plasticity. Iron-silicon steel is an interesting, model BCC material since the evolution of the dislocation structure in specifically-oriented grains and at particular grain boundaries have far-reaching effects not only on the deformation behaviour but also on the magnetic properties, which are important in its final application as electrical steel. In this study, two different orientations of micropillars (1, 2, 4 microns in diameter) and macropillars (2500 microns) and their corresponding bi crystals are analysed after compression experiments with respect to the effect of size on strength and dislocation structures. Using different experimental methods, such as slip trace analysis, plane tilt analysis and cross-sectional EBSD, we show that direct slip transmission occurs, and different slip systems are active in the bi-crystals compared to their single-crystal counterparts. However, in spite of direct transmission and a very high transmission factor, dislocation pile-up at the grain boundary is also observed at early stages of deformation. Moreover, an effect of size scaling with the pillar size in single crystals and the grain size in bi-crystals is found, which is consistent with investigations elsewhere in FCC metals.

Dislocation Character Transition and Related Mechanical Response in a Body-Centered Cubic Single Crystal

Direct Observation of Plastic Deformation in Iron–3% Silicon Single Crystal by in Situ Nanoindentation in Transmission Electron Microscopy

Mass Transfer and Morphology Change Via Dislocation Emission in a Macroporous FCC Metal

High Strain Gradient Plasticity Associated with Wedge Indentation into Face-Centered Cubic Single Crystals: Geometrically Necessary Dislocation Densities

Deformation of micrometer and mm-sized Fe2.4wt.%Si single- and bi-crystals with a high angle grain boundary at room temperature

In Situ Investigation of Synchronized Dislocation Array Nucleation and Phase Transformation at Mode I-II Cracks of Single-Crystalline Mo

Dislocation assisted face-centered-cubic/body-centered-cubic interface mixing during severe plastic deformation

Plasticity Initiation And Evolution During Nanoindentation Of An Iron-3% Silicon Crystal

Deformation of Μm- and Mm-Sized Fe2.4wt%Si Single- and Bi-Crystals with a High Angle Grain Boundary at Room Temperature

In situ observation of dislocations at crack tip insingle crystalline tantalum

Dislocation “Bubble-Like-effect” and the Ambient Temperature Super-plastic Elongation of Body-centred Cubic Single Crystalline Molybdenum

In-Situ Tem Compression of Submicron-Sized Single Crystal Copper Pillars

Plastic Deformation of Submicron-Sized Crystals Studied by In-Situ Kikuchi Diffraction and Dislocation Imaging

Amorphization and Dislocation Evolution Mechanisms of Single Crystalline 6H-SiC

In Situ Tem Study of Deformation-Induced Crystalline-To-Amorphous Transition in Silicon

Unravelling the jerky glide of dislocations in body-centred cubic crystals

The Investigation of Size Effect for Dislocation Starvation Mechanism UNDER Cu Single-Crystal Micro-Pillar Compression

A Micropillar Compression Simulation by A Multiscale Plastic Model Based on 3-D Discrete Dislocation Dynamics

Dynamic Interactions Between Non-Screw Dislocations and Stacking Faults During in Situ Straining in a TEM

In-situ TEM Investigation of Fracture Process in an Al–Cu–Mg Alloy

In?situ TEM investigation of dislocation multiplication in front of crack in body?centered cubic single crystal niobium