Abstract:This article presents a wideband millimeter-wave power amplifier (PA) with a capacitive stability enhancement technique. It is composed of three differential cascode stages to attain high-power gain and large output power. To ensure the stabilization of the amplifier, a robust technique based on a series base capacitor is proposed and applied in each stage. Each capacitor creates a low-frequency zero to adjust the phase and amplitude responses of the differential cascode structure. As a result, the phase margin of the loop gain is increased remarkably. By adjusting the series base capacitors, the low-frequency zeros and gains of the three stages can be optimized. Therefore, the operating bandwidth is also extended. Meanwhile, a transformer-based four-path power combination network with a large current capacity is developed to further enlarge the output power. The circuit is demonstrated in a commercial 0.13 μm SiGe BiCMOS process. According to the measurement results, the PA obtains a saturated output power (P Sat ) of 18.5 dBm and output referred 1-dB compression point (OP 1dB ) of 16.32 dBm at 77 GHz. The tested small-signal gain is 26.7 dB at 77 GHz. Its 3 dB gain bandwidth is beyond 21.5 GHz, which ranges from 68.5 to 90 GHz. The P Sat variation is less than 0.57 dB at the frequency range from 70 to 85 GHz. The measurement also shows the PA with the proposed technique is unconditionally stable over the entire frequency band. The chip area is only 0.684 mm 2 .

142 GHz Amplifier with 18.5 Db Gain and 7.9 Mw DC Power in 65 Nm CMOS

A compact, fully differential D-band CMOS amplifier in 65nm CMOS

A Three Stage, Fully Differential 128–157 GHz CMOS Amplifier with Wide Band Matching

A 68.5~90 GHz High-Gain Power Amplifier with Capacitive Stability Enhancement Technique in 0.13 Μm SiGe BiCMOS

A Compact 2.1–39 GHz Self-Biased Low-Noise Amplifier in 65 Nm CMOS Technology

Compact 50-62 GHz Current-Reused Low-Noise Amplifier with Gate-Drain Transformer Feedback

A 60GHz power amplifier with 12.1 dBm & P1dBCP in 0.18um SiGe BiCMOS process

A 100–117 GHz W-Band CMOS Power Amplifier With On-Chip Adaptive Biasing

A 4 W K-Band Gaas Mmic Power Amplifier With 22 Db Gain

Design of X/Ku Dual-Wideband GaN Power Amplifier MMIC Based on Coupled Multiresonator Matching Networks

A Wideband Power Amplifier in 65 nm CMOS Covering 25.8 GHz–36.9 GHz by Staggering Tuned MCRs

A 130–150 GHz Power Amplifier for Millimeter Wave Imaging in 65-Nm CMOS

A 180 GHz High-Gain Cascode Amplifier in 130-Nm SiGe Process

A 110 GHz Feedback Amplifier Design Based on Quasi-Linear Analysis

A 21-to-41-GHz High-Gain Low Noise Amplifier With Triple-Coupled Technique for Multiband Wireless Applications

A 150GHz amplifier based on coupled transmission line neutralization and inter stage impedance matching with 20dB gain in 65nm CMOS

180 GHz high-gain cascode power amplifier in a 130 nm SiGe process

A 68–79 GHZ 15.6DBM Power Amplifier in 65NM CMOS

A 143ghz Power Amplifier Based On Over Neutralization And Power Combining Technique In 65nm Cmos

A Two-Way Current-Combining W-band Power Amplifier Achieving 17.4-Dbm Output Power with 19.4% PAE in 65-Nm Bulk CMOS

A Compact 140-Ghz CMOS Power Amplifier with 10.5-Dbm Output Power and 27.6-Db Power Gain Supporting Up to 128-QAM Modulation