Abstract:A digital deconvolution method with pile-up reconstruction has been proposed for scintillator detectors for high rate photon-counting X-ray imaging applications. The detector signal was modeled as an exponential decay waveform convoluted with the single photon response of the SiPM detector. An impulse signal can be obtained by digital deconvolution (unfolding) with much shorter duration, which was then used for energy estimation followed by a trapezoid filter and pile-up discrimination The whole digital deconvolution algorithm has been synthesized and verified by both SIMULINK simulation and experimental tests. The prototype of the detector and the readout electronics were developed for demonstration, using 3 mm x 3 mm x 10 mm LYSO scintillator coupled with a 3 mm x 3 mm SenSL SiPM. A 14 bit, 100 MSPS ADC was used to sample the analog waveform and the digital filter was implemented in a Xilinx Kintex 7 FPGA. The signal width was shortened from similar to 250 ns to 10 similar to 20 ns and then was shaped into trapezoidal pulse with 100 ns width. The energy was estimated from the trapezoid top for better signal collection and noise rejection. The unfolded pulses were used for pile-up discrimination and to reconstruct two pile-up signals from the overlapped trapezoid outputs. The energy performance of the prototype system was firstly validated by measuring the energy spectrums of Am-241, Co-57, Na-22 and Cs-137 radiation sources. The energy resolutions were measured to be 36.9%, 29.9%, 13.9% and 12.9% respectively at 59.5 keV, 122 keV, 511 keV and 662 keV in FWHM. High rate performance was evaluated by an X-ray generator. The maximum output counting rate was measured to 5.36 Mcps without saturation, comparing with the saturated counting rate of 2.34 Mcps using the original LYSO signals The saturation counting rate using digital deconvolution was estimated to be up to similar to 7 Mcps fitted with the paralyzable dead time model, corresponding to similar to 20 Mcps input count rate.

The Digital Penalized Lms Deconvolution Method for Tpc X-Ray Polarimeter Signal Processing

Polarisation-modulated Photon-Counting 3D Imaging Based on a Negative Parabolic Pulse Model

Electron Track Reconstruction and Improved Modulation for Photoelectric X-ray Polarimetry

Analytical Noise Treatment for Low-Dose Ct Projection Data by Penalized Weighted Least-Square Smoothing in the K-L Domain

Deep Ensemble Analysis for Imaging X-ray Polarimetry

Non-negative sparse deconvolution method for PMT signals in radiation detectors

Effectiveness Study of Calibration and Correction Algorithms on the Prototype of the POLAR-2/LPD Detector

Trapezoidal Shaping Algorithm Based on Digital Penalized LMS Method

Digital Deconvolution Of Scintillation Detector Signals For High Rate Photon-Counting X-Ray Imaging Applications

A deep ensemble approach to X-ray polarimetry

Simulation of photoelectric X-ray polarimetry and reconstruction of the photoelectron azimuthal angle

A Novel Method to Measure the De/dx Resolution of a TPC Prototype Using 266 Nm UV Laser

The Development of a Readout ASIC for TPC Based X-ray Polarimeter

Polarization Leakage and the IXPE PSF

Polarization Leakage and the IXPE Point-spread Function

Equalizing the Pixel Response of the Imaging Photoelectric Polarimeter On-Board the IXPE Mission

Research on the X-Ray Polarization Deconstruction Method Based on Hexagonal Convolutional Neural Network

Application of Physics-Informed Neural Networks in Removing Telescope Beam Effects

Design and Evaluation of LYSO/SiPM LIGHTENING PET Detector with DTI Sampling Method

Research on the X-Ray Polarization Deconstruction Method Based on Hexagonal Convolutional Neural Network

A Multi-Purpose Readout Electronics for CdTe and CZT Detectors for X-Ray Imaging Applications