Abstract:We perform simulations to compute the effective potential between the centers-of-mass of two polymers with reversible bonds. We investigate the influence of the topology of the unbonded precursor (linear or ring) and the specific sequence of the reactive groups (from purely random to periodic), establishing that both have a strong impact on the effective potential. When the reactive sites of both polymers are chemically orthogonal so that only intramolecular bonds are possible, the interactions become more repulsive the closer to periodic the sequence is. The opposite effect is found if both polymers have the same type of reactive sites and intermolecular bonds can be formed. We test the validity of the effective potentials in solution, from high dilution to far above the overlap concentration, by comparing simulations of the effective fluid with those of the real all-monomer system. Very good agreement is found for the reversible linear polymers, indicating that unlike in their non-bonding counterparts many-body effects are minor even far above the overlap concentration. The agreement for the reversible rings is less satisfactory, and at high concentration the real system does not show the clustering behavior predicted by the effective potential. Results similar to the former ones are found for the partial self-correlations in ring/linear mixtures. Finally, we investigate the possibility of creating a gel of two interpenetrated reversible networks. For this purpose we simulate a 50/50 two-component mixture of reversible polymers with orthogonal chemistry for the reactive sites, so that intermolecular bonds are only formed between polymers of the same component. As predicted by both the theoretical phase diagram and the simulations of the effective fluid, the two networks in the all-monomer mixture do not interpenetrate and phase separation (demixing) is observed instead.

Equilibrium Polymerization with Reversible Termination

Modeling for the Diffusion Limitation of Free Radical Polymerization

Modeling and Experimentation of RAFT Solution Copolymerization of Styrene and Butyl Acrylate, Effect of Chain Transfer Reactions on Polymer Molecular Weight Distribution

Modeling and Simulation of Semibatch Emulsion Polymerization

Theoretical Study on the High Polymer Molecular Weight of Heteroatom-Substituted Constrained Geometry Catalyst

Effect of Temperature Switching and Dynamic Phase Equilibrium on Polymer Microstructure in Condensed-Mode Operation

Entropy-induced Separation of Binary Semiflexible Ring Polymer Mixtures in Spherical Confinement.

Kinetics and thermodynamics of reversible polymerization in closed systems

Modeling Analysis of Chain Transfer in Reversible Addition‐fragmentation Chain Transfer Polymerization

General Kinetic Model of Imperfect Living Polymerization (IV)

Copolymer Randomization by End‐Group Interchain Exchange Reactions

Accurate Determination of Reactivity Ratios for Copolymerization Reactions with Reversible Propagation Mechanisms

A Sequential Variable Decoupling Method For Rigorous Calculation Of Molecular Weight Distribution Of Batch Free Radical Polymerization

Monte Carlo Simulations Of Atom Transfer Radical (Homo)Polymerization Of Divinyl Monomers: Applicability Of Flory-Stockmayer Theory

On the Validity of Effective Potentials in Crowded Solutions of Linear and Ring Polymers with Reversible Bonds

Mass and Heat Diffusion in Ternary Polymer Solutions: A Classical Irreversible Thermodynamics Approach

Polymerization of Branched Polyetherimides: Comparison between Monte Carlo Simulation and Flory-Stockmayer Theory

Development of Termination Mechanism of Radical Polymerization

One Reagent with Two Functions: Simultaneous Living Radical Polymerization and Chain-End Substitution for Tailoring Polymer Dispersity

Modelling and Kinetic Study on Radical Polymerization of Methyl Methacrylate in Bulk, 1. Propagation and Termination Rate Coefficients and Initiation Efficiency

Competing exchange and irreversible reactions in a linear co-polycondensation lead to a broad composition window where tunable high molecular weight polymers can be prepared