Abstract:This paper describes a novel hydride atomizer based on atmospheric pressure dielectric barrier discharge (DBD) plasma. The plasma was generated with a 3700-V, 20.3-kHz, and 5-W electrical power supply and easily sustained with inert gases (He or Ar) at a flow rate of 250 mL(.)min(-1) after optimization. However, it cannot be sustained with N-2. Ibis atomizer offers the advantages of low operation temperature and low power consumption in comparison with the currently used electrothermal quartz atornization operated at 900 degrees C with a power supply of several hundred watts. To confirm the utility of the proposed atomizer, four arsenic species (As(III), As(V), monomethylarsonic acid (MMA), dimethylarsinic acid (DMA)) were determined by the present atornization technique. A hyphenation of HPLC coupled to hydride generation AAS with the optimized DBD atomizer has been successfully used for the speciation of arsenic in order to demonstrate the potential of this atomizer in the present study. The characteristics of the DBD atomizer and the effects of different parameters (discharge gas, gas flow rate, voltage, HCl concentration, KBH4 concentration) are discussed in the paper. Compared with other hydride atornization techniques, the proposed method shows the following features: (1) small size (70 mm x 15 mm x 5 mm), which is preferable for the miniaturization of the total analytical system; (2) low power consumption (:55 W), which indicates the possibility of the development of portable, fieldable analytical instrumentation for in situ detection using battery as power supply; (3) low atomizer temperature (similar to 70 degrees C), which is in favor of the compactness of the total instruments; (4) avoidance of residue moisture removal in comparison with the existed GD system, which leads to the facility of the system. The analytical figures of the present technique were evaluated. The detection limits of As(III), As(V), MMA, and DMA obtained with HG-DBD-AAS were 1.0, 11.8, 2.0, and 18.0 mu g(.)L(-1), respectively. The accuracy of the system was verified by the determination of arsenic in reference material of orchard leaves SRM 1571,. The concentration of As determined by the present method agreed well with the reference values. The speciation of arsenic in the freeze-dried urine SRM 2670 were carried out, and the results obtained were in agreement with the results of HPLC-ICPMS and the reported values by other laboratories.

Flow Injection Hydride Generation for On-Atomizer Trapping: Highly Sensitive Determination of Cadmium by Tungsten Coil Atomic Absorption Spectrometry

Flow injection hydride generation and on-line W-coil trapping for electrothermal vaporization dielectric barrier discharge atomic emission spectrometric determination of trace cadmium

Flow Injection–electrochemical Hydride Generation Technique for Atomic Absorption Spectrometry. Invited Lecture

In-situ Detection of Cadmium with Aptamer Functionalized Gold Nanoparticles Based on Smartphone-Based Colorimetric System

Flow Injection On-Line Coprecipitation Preconcentration for Electrothermal Atomic Absorption Spectrometry

Evaluation of Tungsten Coil Electrothermal Vaporization-Ar/h2 Flame Atomic Fluorescence Spectrometry for Determination of Eight Traditional Hydride-Forming Elements and Cadmium Without Chemical Vapor Generation.

A Sequential Injection On-Line Column Preconcentration System for Determination of Cadmium by Electrothermal Atomic Absorption Spectrometry

Development of a New and Highly Sensitive Method for Arsenic Determination in Drinking Water Samples Using Au‐Coated W‐Coil Atom Trap Hydride Generation Atomic Absorption Spectrometry

Determination of cadmium in biological materials by flame atomic absorption spectrometry with flow-injection on-line sorption preconcentration

Development of a miniaturized hydride generation-dielectric barrier discharge atomic absorption spectrometer

Atomization of Hydride with A Low-Temperature, Atmospheric Pressure Dielectric Barrier Discharge and Its Application to Arsenic Speciation with Atomic Absorption Spectrometry

Determination of Metals in Environmental Waters by Solution Cathode Glow Discharge -Atomic Emission Spectroscopy (SCGD-AES) with a Syringe Pump for Sample Introduction

Simultaneous Measurements of Cr, Cd, Hg and Pb Species in Ng L-1 Levels by Interfacing High Performance Liquid Chromatography and Inductively Coupled Plasma Mass Spectrometry.

An Efficient Flow-Injection System with On-Line Ion-Exchange Preconcentration for the Determination of Trace Amounts of Heavy Metals by Atomic Absorption Spectrometry

THE DETERMINATION OF TRACE AMOUNTS OF HEAVY-METALS IN WATERS BY A FLOW-INJECTION SYSTEM INCLUDING ION-EXCHANGE PRECONCENTRATION AND FLAME ATOMIC-ABSORPTION SPECTROMETRIC DETECTION

Flow injection on-line sorption preconcentration coupled with hydride generation atomic fluorescence spectrometry for determination of (ultra)trace amounts of arsenic(III) and arsenic(V) in natural water samples

Direct Determination of Lead and Cadmium in Distilled Spirits by Inductively Coupled Plasma Mass Spectrometry Coupled with Chip-Based Microflow Injection System

New Developments in Flow Injection Vapor Generation Atomic Absorption Spectrometry

Evaluation of a Hydride Generation-Atomic Fluorescence System for the Determination of Arsenic Using a Dielectric Barrier Discharge Atomizer

Determination of trace cobalt, nickel and cadmium by on-line flow injection analysis with coprecipitation preconcentration FAAS

Determination of Germanium and Tin and Inorganic Tin Species by Hydride Generation in Situ Trapping Flame Atomic Absorption Spectrometry